Home > APRISM > APRISM MI12 Wi-Fi 6 Dual Radio Router User Guide

APRISM MI12 Wi-Fi 6 Dual Radio Router User Guide

Quick Start Guide  
Wi-Fi 6 AX6000 Dual-Radio Indoor Router  
Model: MI12  
Your AP  
1
3
1
2
No.  
1
2
3
WAN: For PoE Power IN/data transfer  
LAN: For data transfer  
Reset  
LED Status  
Flash Green / Off every second The device is boo�ng up  
Flash Red / Off every second  
Steady Green  
The device has lost network connec�vity  
The device is operated in standalong mode  
The device is connec�ng to PrismX  
The device is under control by PrismX  
FW upgrading  
Flash Blue / Off every second  
Steady Blue  
Flash Green / Red every second  
Insttalling the Ceiling Mount with T-bar Clips  
Secure 2 clips on the T-bar of the ceiling with  
M4x6mm screws.  
Install the moun�ng bracket on the clips with 2  
M3.5x16mm screws.  
1
2
Insert RJ45 cables to WAN/LAN port of MI12.  
Turn and secure MI12 to the moun�ng bracket.  
3
4
Accessing the AP’s Se�ngs Menu  
1. Configure your PC’s IP seng to DHCP to automa�cally retrieve an IP address.  
2. Connect your PC’s Wi-Fi to the SSID printed on the rear of the AP that corresponds to the frequency of  
the connec�on (2.4G / 5G) using the password “passphrase”  
3. Enter the IP address 192.168.2.1 in your browser.  
4. In the PRISM login screen use the following login:  
Username: prism  
Password: prism  
1. Configure your PC’s IP seng to sta�c and then set the IP address to any address from 192.168.19.2 to  
192.168.19.250.  
2. Connect your PC’s network port to the WAN port on the AP.  
3. Enter the IP address 192.168.19.1 in your browser.  
4. In the PRISM login screen use the following login:  
Username: prism  
Password: prism  
3
1. Configure your PC’s IP seng to DHCP to automa�cally retrieve an IP address.  
2. Connect your PC’s network port to any of the LAN port on the AP.  
3. Enter the IP address 192.168.2.1 in your browser.  
4. In the PRISM login screen use the following login:  
Username: prism  
Password: prism  
3
Labeling  
The marking information is located at the bottom of the apparatus.  
3
Label  
Regulatory Statements  
Federal Communication Commission Interference Statement  
This equipment has been tested and found to comply with the limits for a Class B digital  
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide  
reasonable protection against harmful interference in a residential installation. This  
equipment generates, uses and can radiate radio frequency energy and, if not installed  
and used in accordance with the instructions, may cause harmful interference to radio  
communications. However, there is no guarantee that interference will not occur in a  
particular installation. If this equipment does cause harmful interference to radio or  
television reception, which can be determined by turning the equipment off and on, the  
user is encouraged to try to correct the interference by one of the following measures:  
-
-
-
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit different from that to which the  
receiver is connected.  
-
Consult the dealer or an experienced radio/TV technician for help.  
FCC Caution: Any changes or modifications not expressly approved by the party  
responsible for compliance could void the user's authority to operate this equipment.  
This device complies with Part 15 of the FCC Rules. Operation is subject to the following  
two conditions: (1) This device may not cause harmful interference, and (2) this device  
must accept any interference received, including interference that may cause undesired  
operation.  
IMPORTANT NOTE:  
Radiation Exposure Statement:  
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled  
environment. This equipment should be installed and operated with minimum distance 20  
cm between the radiator & your body.  
This transmitter must not be co-located or operating in conjunction with any other  
antenna or transmitter.  
Country Code selection feature to be disabled for products marketed to the  
US/CANADA  
Operation of this device is restricted to indoor use only.  
Industry Canada statement:  
This device contains licence-exempt transmitter(s)/receiver(s) that comply with  
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).  
Operation is subject to the following two conditions:  
(1) This device may not cause interference  
(2) This device must accept any interference, including interference that may cause  
undesired operation of the device  
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme  
aux CNR d’Innovation, Sciences et Développement économique Canada applicables  
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions  
suivantes :  
(1) L’appareil ne doit pas produire de brouillage;  
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est  
susceptible d’en compromettre le fonctionnement.  
Caution:  
the device for operation in the band 5150–5250 MHz is only for indoor use to reduce the  
potential for harmful interference to co-channel mobile satellite systems;  
Avertissement:  
les dispositifs fonctionnant dans la bande de 5150 à 5250MHz sont réservés  
uniquement pour une utilisation à l'intérieur afin de réduire les risques de brouillage  
préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux;  
Radiation Exposure Statement:  
This equipment complies with Canada radiation exposure limits set forth for an  
uncontrolled environment. This equipment should be installed and operated with  
minimum distance 20 cm between the radiator & your body.  
Déclaration d'exposition aux radiations:  
Cet équipement est conforme Canada limites d'exposition aux radiations dans un  
environnement non contrôlé. Cet équipement doit être installé et utilisé à distance  
minimum de 20 cm entre le radiateur et votre corps.  
GeneralDetails
NameAPRISM MI12 Wi-Fi 6 Dual Radio Router User Guide
MakeAPRISM
LanguageEnglish
FiletypePDF (Download)
File size0.86 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

If you have any questions regarding APRISM MI12 Wi-Fi 6 Dual Radio Router User Guide, please ask here and describe the problem in detail.

Leave a Reply

Your email address will not be published. Required fields are marked *

16 − thirteen =

APRISM MI12 AX6000 Wi-Fi 6 Dual Radio Router User Guide
APRISM MI12 AX6000 Wi-Fi 6 Dual Radio Router User Guide

APRISM MI12 Wi-Fi 6 Dual Radio Router User Guide
Get PDF manual for the APRISM MI12 Wi-Fi 6 Dual Radio Router User Guide for free. Access setup steps, installation & Wi-Fi configuration, and troubleshooting tips. 👉 View user guide online or download now!