NOKIA FRRX504C 5G Field Router User Guide
and must not be co-located or operating in conjunction with any
other antenna or transmitter. End-users and installers must be
provided with antenna installation instructions and consider
removing the no-collocation statement.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en
même temps qu'aucune autre antenne ou émetteur. Cet
équipement devrait être installé et actionné avec une distance
minimum de 20 centimètres entre le radiateur et votre corps.
3.Le gain maximal d’antenne permis (pour les dispositifs utilisant
la bande 5725-5850 MHz) doit se conformer à la limite de p.i.r.e.
spécifiée pour l’exploitation point à point et non point à point,
selon le cas.
Radio Settings
1. Choose Network > Radio Settings.
2. On Radio Settings page, you can set the configuration of
network.
3. In the Status list, you can view the RF status, such as Frequency,
RSSI, RSRP, RSRQ, CINR, SINR, Cell ID and etc.
Device management settings
FCC Statement
ISED Warning statements
Connect to the network
Software Configuration
Login to the Web management page
FAQs
1. Choose Settings > Device Information
2. On the Device Information page, you can view Device Serial
Number, IMEI, IMSI and Software Version.
3. Choose Settings > System > TR069
4. On the TR069 page, you can view/set Device management/
TR069 parameters.
When the router is powered on, power LED should turn green.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
The POWER indicator does not turn on.
This device complies with Industry Canada’ s licence-exempt
RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of the device.
1. Make sure that the power cable is connected properly and the
router is powered on.
When the SIM card is installed, router begins the activation/
provisioning process and attempts to connect to the network. This
process may take a few minutes. When the connection is established
the NET LED will turn green.
address bar, and press Enter.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Caution!
ISED Statement
2. Make sure that the power supply is compatible with the router.
Fails to Login the web management page.
1. Make sure that the router is powered on.
2. Verify that the router is correctly connected to the computer
through Wi-Fi or a network cable.
3. If the problem persists, please contact the authorized local
service suppliers.
1.The device for operation in the band 5150–5250 MHz is only
for indoor use to reduce the potential for harmful interference
to co-channel mobile satellite systems;
Le présent appareil est conforme aux CNR d’ Industrie Canada
applicables aux appareils radio exempts de licence.
L’ exploitation est autorisée aux deux conditions suivantes :
(1) l’ appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Signal LEDs indicate the RF signal strength.
2. Enter the username and password, and click Login.
3. After the password is verified, you can login to the web
management page.
2.For devices with detachable antenna(s), the maximum antenna
gain permitted for devices in the bands 5250-5350 MHz and
5470-5725 MHz shall be such that the equipment still complies
with the e.i.r.p. limit;
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
Indicator
PWR
Status
Description
Power on
Steady on
The router fails to search for the wireless network.
1. Check if the power supply is connected properly.
2. Check if the router is placed in an open area that is far away
from obstructions, such as concrete or wooden walls.
3. If the problem persists, please contact the authorized local
service suppliers.
Off
No power supply
—Reorient or relocate the receiving antenna.
Steady on
Registered to network
3.For devices with detachable antenna(s), the maximum antenna
gain permitted for devices in the band 5725-5850 MHz shall be
such that the equipment still complies with the e.i.r.p. limits
specified for point-to-point and non-point-to-point operation as
appropriate.
ISED Radiation Exposure Statement
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Off
Not register/SIM LOCK/PIN LOCK
Network searching
NET
SIM
The device meets the exemption from the routine evaluation
limits in section 2.5 of RSS 102 and compliance with RSS-102 RF
exposure, users can obtain Canadian information on RF exposure
and compliance.
Blinking
(500ms interval)
—Consult the dealer or an experienced radio/TV technician for
help.
The parameters are restored to default values.
Steady on
SIM ready
1. If the router is powered off unexpectedly while being configured,
the parameters may be restored to the default settings.
2. After configure the parameters, download the configuration file
and restore the desired settings quickly.
1.Les dispositifs fonctionnant dans la bande 5150-5250 MHz
sont réservés uniquement pour une utilisation à l’intérieur afin
de réduire les risques de brouillage préjudiciable aux systèmes
de satellites mobiles utilisant les mêmes canaux;
Off
No SIM or SIM error
FCC Radiation Exposure Statement
Le dispositif rencontre l'exemption des limites courantes
d'évaluation dans la section 2.5 de RSS 102 et la conformité à
l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information
canadienne sur l'exposition et la conformité de rf.
Indicate the RF signal strength:
This device complies with FCC radiation exposure limits set
forth for an uncontrolled environment and it also complies with
Part 15 of the FCC RF Rules. This equipment must be installed
and operated in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons
RSRP -85~-30 dBm: 3 LEDs on
RSRP -120~-85 dBm: 2 LEDs on
RSRP -135~-120 dBm: 1 LED on
Steady on
RSSI
2.Le gain maximal d’antenne permis pour les dispositifs utilisant
les bandes 5250-5350 MHz et 5470-5725 MHz doit se
conformer à la limite de p.i.r.e.;
The default username and password are both admin. If you want
to view or configure the router, you should use the super account
to login to the web management page. The default super
username is superadmin, and the password is admin.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter. This
equipment should be installed and operated with a minimum
distance of 20 centimeters between the radiator and your body.
Off
No signal
Blinking one by one
Firmware upgrade
8
9
10
11
12
13
14
15
16
17
| General | Details |
|---|---|
| Name | NOKIA FRRX504C 5G Field Router User Guide |
| Make | Nokia |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.75 MB |
(1 votes, average: 5.00 out of 5)
Loading...
If you have any questions regarding NOKIA FRRX504C 5G Field Router User Guide, please ask here and describe the problem in detail.
NOKIA ONT G-1426G-A Dual Band Wi-Fi 6 Mesh Router User Guide
PIX-LINK LV-WR09 Wireless-N Repeater AP Router Installation Guide
TP-Link BE5000 Dual-Band Wi-Fi 7 Router Installation Guide
VIMAR 01507 By me KNX Router Instruction Manual
D-Link AX3200 Router Owner’s Manual
inseego 5G Router FG2000 User Guide
Cudy P4 Dual Band Whole Home Mesh Wi-Fi Router Installation Guide
DrayTek Vigor 2927 Dual Wan Security Router User Guide
MEIG SLT866 4G LTE CPE Router User Guide
Siretta GPS 5G NR Router User Guide
cradlepoint CTR35 Wireless Router User Guide