Shenzhen Xinfengweiye Technology U850 4G Wireless Router User Manual

1

2

3

4

5

6

7

8

9

10

11

12

13

In August 1986 the Federal Communications Commission (FCC) of the United States with its action in Report and  

Outer FCC 96-326 adopted an updated safety standard for human exposure to radio frequency (RF) electromagnetic  

energy emitted by FCC regulated transmitters. Those guidelines are consistent with the safety standard previously set  

by both U.S. and international standards bodies. The design of this 4G Wireless Router complies with the FCC  

guidelines and these international standards. Use only the supplied or an approved antenna. Unauthorized antennas  

modifications, or attachments could impair call quality, damage the 4G Wireless Router, or result in violation of FCC  

regulations. Do not use the 4G Wireless Router with a damaged antenna. If a damaged antenna comes into contact  

with the skin, a minor burn may result. Please contact your local dealer for replacement antenna.  

BODY-WORN OPERATION:  

This device was tested for typical body-worn operations with the back/front of the 4G Wireless Router kept 5mm from  

the body. To comply with FCC RF exposure requirements, a minimum separation distance of 5m m must be maintained  

between the user's body and the back/front of the 4G Wireless Router, including the antenna. Third-party belt-clips,  

holsters and similar accessories containing metallic components shall not be used. Body-worn accessories that cannot  

maintain 5m m separation distance between the user’s body and the back/front of the 4G Wireless Router, and have not  

been tested for typical body-worn operations may not comply with FCC RF exposure limits and should be avoided.  

For more information about RF exposure, please visit the FCC website at www.fcc.gov  

Your wireless handheld portable 4G Wireless Router is a low power radio transmitter and receiver. When it is ON, it  

receives and also sends out radio frequency (RF) signals. In August, 1996, the Federal Communications Commissions  

(FCC) adopted RF exposure guidelines with safety levels for hand-held 4G Wireless Router. Those guidelines are  

consistent with the safety standards previously set by both U.S. and international standards bodies:  

<ANSIC95.1> (1992) / <NCRP Report 86> (1986) / <ICNIRP> (1999)  

Those standards were based on comprehensive and periodic evaluations of the relevant scientific literature. For  

example, over 120 scientists, engineers, and physicians from universities, government health agencies, and industry  

reviewed the available body of research to develop the ANSI Standard (C95.1). Nevertheless, we recommend that you  

use a hands-free kit with your 4G Wireless Router (such as an earpiece or headset) to avoid potential exposure to RF  

energy. The design of your 4G Wireless Router complies with the FCC guidelines (and those standards).  

Use only the supplied or an approved replacement antenna. Unauthorized antennas, modifications, or attachments  

could damage the 4G Wireless Router and may violate FCC regulations.  

NORMAL POSITION:  

Hold the 4G Wireless Router as you would any other 4G Wireless Router with the antenna pointed up and over your  

shoulder.  

RF Exposure Information:  

This product is compliance to FCC RF Exposure requirements and refers to FCC website  

https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm  

information include SAR Values.  

search for FCC ID: 2AWCR-U850 to gain further  

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:  

(1) this device may not cause harmful interference, and  

(2) this device must accept any interference received, including interference that may cause undesired operation.  

NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to  

this equipment. Such modifications could void the user’s authority to operate the equipment.  

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to  

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a  

residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and  

used in accordance with the instructions, may cause harmful interference to radio communications. However, there is  

no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful  

interference to radio or television reception, which can be determined by turning the equipment off and on, the user is  

encouraged to try to correct the interference by one or more of the following measures:  

- Reorient or relocate the receiving antenna.  

- Increase the separation between the equipment and receiver.  

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  

-Consult the dealer or an experienced radio/TV technician for help  

Do not use the device with the environment which below minimum -10℃ or over maximum 50℃, the device may  

not work.  

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void  

the user’s authority to operate the equipment.  

This device is acting as slave and operating in the 2.4 GHz (2412 ~2462 MHz) band. Ad Hoc function is supported but  

not able to operate on non-US frequencies.  

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	Shenzhen Xinfengweiye Technology U850 4G Wireless Router User Manual
Make	Shenzhen Xinfengweiye Technology
Language	English
Filetype	PDF (Download)
File size	0.33 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL WI-FI INSTRUCTIONS & USER MANUALS
• Shenzhen Xinfengweiye Technology

Questions and Answers (0)

If you have any questions regarding Shenzhen Xinfengweiye Technology U850 4G Wireless Router User Manual, please ask here and describe the problem in detail.