Home > aparian > aparian A-DH485R/B Router User Guide

aparian A-DH485R/B Router User Guide

Revision 1.5  
01/2023  
REQUIRED SOFTWARE  
The DH485 Router/B requires Aparian Slate software to setup and configure. The software installation  
MODULE INSTALLATION  
The module has two Ethernet ports located at the lower front of the module. There are also two ports  
at the bottom of the module for RS232/RS485 serial and power. The power port uses a three-way  
connector which is used for the DC power supply positive and negative (or ground) voltage as well as  
the earth connection.  
The nine-way connector is used to connect the RS232 and RS485 conductors for serial  
communication. The shield terminal can be used for shielded cable in high noise environments.  
LED  
Ok  
Description  
The module LED will provide information regarding the system-level operation of the  
module.  
If the LED is red, then the module is not operating correctly. For example, if the  
module application firmware has been corrupted or there is a hardware fault the  
module will have a red Module LED.  
If the LED is green (flashing), then the module has booted and is running correctly  
without any application configuration loaded.  
Document No. D120-018  
Page 2 of 4  
GeneralDetails
Nameaparian A-DH485R/B Router User Guide
Makeaparian
LanguageEnglish
FiletypePDF (Download)
File size0.11 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

If you have any questions regarding aparian A-DH485R/B Router User Guide, please ask here and describe the problem in detail.

Leave a Reply

Your email address will not be published. Required fields are marked *

five × 2 =

aparian A-CNTR ControlNet Router Module User Guide
aparian A-CNTR ControlNet Router Module User Guide

aparian A-DH485R/B Router User Guide