Home > HIRSCHMANN > HIRSCHMANN NB1810 NetModule Router User Manual

HIRSCHMANN NB1810 NetModule Router User Manual

In general, a link will be only dialed or declared as up if the following prerequisites are met:  
Condition  
WWAN WLAN  
ETH  
PPPoE  
Modem is registered  
X
X
X
Registered with valid service type  
Valid SIM state  
Sufficient signal strength  
Client is associated  
X
X
X
X
X
X
X
Client is authenticated  
Valid DHCP address retrieved  
Link is up and holds address  
Ping check succeeded  
X
X
X
X
X
X
X
X
X
The menu can be used further to prioritize your WAN links. The highest priority link which has been  
established successfully will become the so-called hotlink which holds the default route for outgoing  
packets.  
In case a link goes down, the system will automatically switch over to the next link in the priority list.  
You can configure each link to be either established when the switch occurs or permanently in order to  
minimize link downtime.  
Parameter  
1st priority  
2nd priority  
WAN Link Priorities  
The primary link which will be used whenever possible.  
The first fallback link, it can be enabled permanently or being dialed  
as soon as Link 1 goes down.  
3rd priority  
4th priority  
The second fallback link, it can be enabled permanently or being di-  
aled as soon as Link 2 goes down.  
The third fallback link, it can be enabled permanently or being dialed  
as soon as Link 3 goes down.  
Links are being triggered periodically and put to sleep in case it was not possible to establish them  
within a certain amount of time. Hence it might happen that permanent links will be dialed in back-  
ground and replace links with lower priority again as soon as they got established. In case of interfering  
links sharing the same resources (for instance in dual-SIM operation) you may define a switch-back  
interval after which an active hotlink is forced to go down in order to let the higher-prio link getting  
dialed again.  
We recommend to use the permanent operation mode for WAN links in general. However, in case  
of time-limited mobile tariffs for instance, the switchover mode might be applicable. By using the  
distributed mode, it is possible to distribute outgoing traffic over multiple WAN links based on their  
weight ratio.  
NB1810  
45  
User Manual for NRSW version 4.8.0.102  
GeneralDetails
NameHIRSCHMANN NB1810 NetModule Router User Manual
MakeHIRSCHMANN
LanguageEnglish
FiletypePDF (Download)
File size MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

If you have any questions regarding HIRSCHMANN NB1810 NetModule Router User Manual, please ask here and describe the problem in detail.

Leave a Reply

Your email address will not be published. Required fields are marked *

seventeen − 7 =

HIRSCHMANN NB1800 NetModule Router User Manual
HIRSCHMANN NB1800 NetModule Router User Manual
HIRSCHMANN NB2810 NetModule Router User Manual
HIRSCHMANN NB2810 NetModule Router User Manual

HIRSCHMANN NB1810 NetModule Router User Manual