MOXA TN-5916 ToughNet NAT Router Installation Guide
STEP 2:
If the spring-loaded bracket is locked in place, push the recessed button
to release it. Once released, you should feel some resistance from the
spring as you slide the bracket up and down a few millimeters in each
direction.
STEP 3:
STEP 4:
Position the ToughNet router on the Swing the router down fully onto
DIN-rail, tilted, so the clamps hook
over the top edge of the rail.
the DIN-rail, until both clamps
completely latch.
To remove the Moxa ToughNet Router from the DIN-rail, use a
screwdriver to pull out the two spring-loaded brackets from the bottom
until they are fixed in a “locked” position. Then, reverse Steps 3 and 4
above.
Wiring Requirements
WARNING
Turn the power off before disconnecting modules or wires. The
correct power supply voltage is listed on the product label. Check
the voltage of your power source to make sure you are using the
correct voltage. Do NOT use a voltage greater than what is
specified on the product label.
These devices must be supplied by a SELV source as defined in
the Low Voltage Directive 2006/95/EC and 2004/108/EC.
- 7 -
| General | Details |
|---|---|
| Name | MOXA TN-5916 ToughNet NAT Router Installation Guide |
| Make | MOXA |
| Language | English |
| Filetype | PDF (Download) |
| File size | 1.85 MB |
If you have any questions regarding MOXA TN-5916 ToughNet NAT Router Installation Guide, please ask here and describe the problem in detail.

MOXA EDR-8010-2GSFP Secure Router Installation Guide

EDR-G9004 Series Moxa Secure Router Installation Guide

MOXA TN-4900 Series Gigabit Security Router Owner’s Manual

MOXA TN-4908-WV-CT-T Tough Net Router Installation Guide

MOXA EDR-810 Secure Router Installation Guide

MOXA EDR-8010 Series Secure Router Installation Guide

MOXA G4302-LTE4-US-T Cellular Router Owner’s Manual




























