NORDIC M1R-DH2-12 Corded Router User Manual
NORDIC
NYLON NUTS
•
ATTENTION: Do not lower the nylon nut is too low, it can lead to excessive lowering of the cutter. Top
position of the motor housing can be adjusted by rotating the nylon nut.
•
ATTENTION: Due to the fact that an excessive depth of cut may lead to overloading of the motor
and mill retention difficulties in operation. Depth of cut should not exceed 15 mm in one pass milling
grooves 8 mm-ing cutter. Routing grooves with 20 mm-ing cutter cutting depth should not exceed
5 mm in one pass. Routing grooves at very large depths when operating, make the work in 2 or 3
passes with a gradual increase in depth.
CLAMP
•
Since the lock has three adjustment bolts- 0.8 mm per rotation, then no adjustment of the locking
rack can be installed three different milling depth. To adjust the bolts, loosen the hex nuts on them
and then make adjustments bolts. After the installation of the selected position of the adjusting
screws, tighten the nut to lock them.
USING THE MACHINE
•
Place the product on the sample surface so that the cutter does not touch the sample. Turn it on, and
wait until the device gains momentum. Release the lock lever and slowly lower the unit down until
they reach a predetermined depth. Then two hands move the device forward. When milling angles
sample surface should be left of the cutter in the direction of flow.
TURNING ON AND OFF THE DEVICE
•
ATTENTION: Before turning to the network, check whether the switch is returned to the start “OFF”
position when you release it. Before switching on the device, make sure that the shaft is released
from the lock. To activate, press the lock and at the same time the start button. For continuous
operation, press the start button and then the button lock. To turn off, release the start button.
PARALLEL GUIDE
•
To set the parallel guide, insert the guide holders into the holes in the base of the device. Adjust the
distance between the cutter and the stop and secure with a screw clamp. When necessary to increase
the distance between the cutter and the rip fence use additional wooden board thickness, which may
be attached to the sample using clamps.
REPLACING CARBON BRUSHES
•
Replace carbon brushes when they are worn down to the limit mark. Brushes should be changed in
pairs.
5
| General | Details |
|---|---|
| Name | NORDIC M1R-DH2-12 Corded Router User Manual |
| Make | NORDIC |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.1 MB |
(1 votes, average: 5.00 out of 5)
Loading...
If you have any questions regarding NORDIC M1R-DH2-12 Corded Router User Manual, please ask here and describe the problem in detail.
Banggood TC66 4G Wireless Router Instruction Manual
Adtran 834-5 SDG PlumeOS Dual-Band Wi-Fi 5 Plume Enabled Ethernet Router User Manual
TP-Link Archer AX55 Wi-Fi 6 Router Installation Guide
SIERRA WIRELESS XR80 5G Cellular Router Instructions
NETGEAR MR7500 M7 Ultra Mobile Router Owner’s Manual
peplink P1MT08 MAX BR1 Classic Automatic Failover 4G LTE Mobile Router User Manual
TP-Link ER706W Wi-Fi Gigabit VPN Router User Guide
PRISMXR P1411 Streaming Link Air Bridge WiFi6 Router User Guide
ioGiant AX1800 Wi-Fi Router Smart Wireless Router Installation Guide
NEXXT NCM-X3000 Bolt AX3000 Router User Guide