SMAWAVE SRP620-B 5G IP67 Ruggedized Router User Guide
Once the router’ s radio module is configured for the SIM card,
it begins the activation/provisioning process and attempts to
connect to the mobile network. This process typically takes
several minutes. A successful connection is indicated by a
solid green NET LED. And the strength of the RF signal can be
indicated by the Signal LEDs in different quantity.
The router does not support SIM card hot-plug,
please confirm that the device is powered off when
the SIM card is inserted or removed.
Labeling requirements.This device complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
The portable device is designed to meet the requirements for expo-
sure to radio waves established by the Federal Communications
Commission (USA).
Choose Network > Radio Settings.
Step1
Step2
tion of 5G NR network.
FAQs
On Radio Settings page, you can set the configura-
Step2 Enter the username and password, and click Login.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause unde-
sired operation.
The POWER indicator does not turn on.
Make sure that the power cable is connected properly
and the router is powered on.
Make sure that the power supply is compatible with the
router.
After the password is verified, you can login to the
Step3
web management page.
In the 5G Status list, you can view the 5G NR status,
such as Frequency, RSSI, RSRP, RSRQ,CINR, SINR, Cell ID
Step3
Changes or modification warning.Any Changes or modifications not
expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
and etc.
Indicator
PWR
Status
Green
Description
Power on
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
This device complies with FCC radiation exposure limits set forth for
an uncontrolled environment and it also complies with Part 15 of the
FCC RF Rules.
This equipment must be installed and operated in accordance with
provided instructions and the antenna(s) used for this transmitter
must be installed to provide a separation distance of at least 20 cm
from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter. End-users and
installers must be provided with antenna installation instructions and
consider removing the no-collocation statement.
Fails to Login the web management page.
Make sure that the router is powered on.
Off
No power supply
Verify that the router is correctly connected to the com-
puter through Wi-Fi or a network cable.
If the problem persists, please contact the authorized
local service suppliers.
Green
Off
Registered to network
Not register to network
NET
Blinking
Green
Searching network
Signal strong
The router fails to search for the wireless
Yellow
Red
Signal good
Signal weak
If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:⑨
network.
RSSI
Check if the power supply is connected properly.
Check if the router is placed in an open area that is far
away from obstructions, such as concrete or wooden walls.
If the problem persists, please contact the authorized
local service suppliers.
Off
No signal
The default username and password are both admin. If you
want to view or configure the router, you should use the super
account to login to the web management page. The default
super username is superadmin, and the password is
admin.
Red Blinking
No SIM or SIM error
-Reorient or relocate the receiving antenna.
⑨ -Increase the separation between the equipment and receiver.
⑨ -Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
⑨ -Consult the dealer or an experienced radio/TV technician
help.
The parameters are restored to default
Software Configuration
values.
If the router is powered off unexpectedly while being
configured, the parameters may be restored to the default
settings.
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. End user must follow the
specific operating instructions for satisfying RF exposure compli-
ance. This transmitter must not be colocated or operating in
conjunction with any other antenna or transmitter.
Radio Settings
Login to the Web Management Page
After configure the parameters, download the configura-
tion file and restore the desired settings quickly.
Step1
the address bar, and press Enter.
7
8
9
10
11
| General | Details |
|---|---|
| Name | SMAWAVE SRP620-B 5G IP67 Ruggedized Router User Guide |
| Make | Smawave |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.08 MB |
(1 votes, average: 5.00 out of 5)
Loading...
If you have any questions regarding SMAWAVE SRP620-B 5G IP67 Ruggedized Router User Guide, please ask here and describe the problem in detail.
Smawave SRG821 Ruggedized Router User Guide
SMAWAVE SRE410 LTE CPE Router User Guide
ENDY ESG610 Cloud Managed VPN Router User Guide
MikroTik RB750r2 hEX Lite Router User Guide
ARRIS M6 Wireless Router User Manual
ASUS ZenWiFi XD4S AX1800 Dual Band WiFi Router User Guide
TELTONIKA Networks RUT241 LTE Router User Guide
APRISM MI12 AX6000 Wi-Fi 6 Dual Radio Router User Guide
CaptionCall CR3 Pcs Modem And Router User Manual
KMC CONTROLS BAC-5051AE BACnet Router Owner’s Manual
Ruijie RG-EG105GW All-in-One Wireless Router User Manual
TP-Link deco 7100000984 Router Installation Guide