Home > Technicolor > technicolor CGA437T Router Instruction Manual

technicolor CGA437T Router Instruction Manual

Damage requiring service  
Unplug this product from the mains supply socket transceiver, this device complies with Industry  
outlet and refer servicing to qualified service Canada’s licence-exempt RSSs. Operation is  
personnel under the following conditions: subject to the following two conditions: (1) This  
• When the power supply, power cord or its plug device may not cause interference; and (2) This  
In case this product is equipped with a wireless  
are damaged.  
• When the attached cords are damaged or  
frayed.  
• If liquid has been spilled into the product.  
• If the product has been exposed to rain or  
water.  
device must accept any interference, including  
interference that may cause undesired operation  
of the device.  
Restricted frequency bands  
In case this product is equipped with a wireless  
transceiver operating in the 2.4 GHz band, it may  
only use channels 1 to 11 (2412 to 2462 MHz) on  
• If the product does not operate normally.  
• If the product has been dropped or damaged in Canada territory.  
any way.  
In case this product is equipped with a wireless  
transceiver operating in the 5 GHz band, it is for  
indoor use only.  
• There are noticeable signs of overheating.  
• If the product exhibits a distinct change in  
performance.  
• If the product is giving off smoke or a burning  
smell.  
Protect the product when moving it  
Always disconnect the power source when  
moving the product or connecting or  
disconnecting cables.  
Interface classifications (upon applicability)  
The external interfaces of the product are  
classified as follows:  
• Cable (IN/OUT): Electrical energy source  
class 1 circuit, not subjected to overvoltages  
(ES1).  
• Phone, FXS: Electrical energy source class 2  
circuit, not subjected to overvoltages (ES2).  
• MoCA, HPNA, RF: Electrical energy source  
class 1 circuit, not subjected to overvoltages  
(ES1).  
• All other interface ports (e.g. Ethernet, USB,...),  
including the low voltage power input from the  
AC mains power supply: Electrical energy  
source class 1 circuit (ES1).  
The availability of some specific channels and/or  
operational frequency bands are country  
dependent and are firmware programmed at the  
factory to match the intended destination. The  
firmware setting is not accessible by the end user.  
North-America - United States of America  
Federal Communications Commission (FCC)  
Compliancy statement  
This device complies with Part 15 of the  
FCC Rules. Operation is subject to the  
following two conditions: (1) this device  
may not cause harmful interference,  
and (2) this device must accept any  
interference received, including  
interference that may cause undesired  
operation.  
Responsible Party - U.S. contact information  
Technicolor Connected Home USA LLC, 4855  
Peachtree Industrial Blvd., Suite 200, Norcross,  
GA 30092 USA, 770-212-9009.  
FCC Caution: Any changes or modifications not  
expressly approved by the party responsible for  
compliance could void the user's authority to  
operate this equipment.  
Regulatory information  
North-America - Canada  
Notification of Canadian Radio Frequency  
interference statement  
FCC Part 15B Supplier’s Declaration of  
Conformity  
The FCC Part 15B Supplier’s Declaration of  
Conformity (SDoC) for your product is available  
at the following internet address:  
This Class B digital apparatus complies with  
Canadian ICES-003.  
This product meets the applicable Innovation,  
Science and Economic Development Canada  
technical specifications.  
Canada - Radiation exposure statement  
This equipment complies with IC radiation  
exposure limits set forth for an uncontrolled  
environment. This equipment should be installed  
and operated with minimum distance 30 cm  
between the radiator and your body.  
Canada - Industry Canada (IC)  
FCC radio frequency interference statement  
This equipment has been tested and found to  
comply with the limits for a Class B digital device,  
pursuant to Part 15 of the FCC Rules. These  
limits are designed to provide reasonable  
protection against harmful interference in a  
residential installation. This equipment generates,  
uses and can radiate radio frequency energy and,  
if not installed and used in accordance with the  
GeneralDetails
Nametechnicolor CGA437T Router Instruction Manual
MakeTechnicolor
LanguageEnglish
FiletypePDF (Download)
File size0.15 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

If you have any questions regarding technicolor CGA437T Router Instruction Manual, please ask here and describe the problem in detail.

Leave a Reply

Your email address will not be published. Required fields are marked *

two × 2 =

technicolor CGA437T Router Instruction Manual