Mercury Netcomm NB16DG Fibre Router User Manual

1

2

Netcomm NB16DG Fibre Configuration  

Using your own router? No worries, we’ve got you covered!  

Log into the gateway:  

1. Ensure your device is connected to the Router (preferably via cable)  

2. Open a web browser  

3. Type the following in the address bar at the top: 192.168.20.1  

4. Default Username: admin  

5. Default Password: password  

This should then give access to the router’s user interface  

(If the password is incorrect you will need to Factory Reset the router by pushing the Inset Reset button on the back for  

10 seconds)  

How to add correct settings for the Mercury network:  

1. Select: Manually set up connection  

2. At the bottom of the page select: Switch to Advanced View  

3. From the top menu select: Network Setup  

4. From the sub-menu select: Network Setup  

On the following page set the following:  

1. Wan Interface: Ethernet WAN  

2. WAN Type: PPP over Ethernet  

3. Username: (your mercury acct number)@mercurybroadband.co.nz  

4. Password: password  

5. Primary DNS: 202.137.240.39  

6. Secondary DNS: 202.137.240.40  

7. Service Name: Mercury  

8. Assigned IP address: (Leave Blank)  

9. MTU: 0  

10. NAT: Enable  

11. Multicast: Disable  

12. IGMP Snooping: Unticked  

13. VLAN Tagging: Ticked - 10  

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	Mercury Netcomm NB16DG Fibre Router User Manual
Make	Mercury
Language	English
Filetype	PDF (Download)
File size	0.07 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL WI-FI INSTRUCTIONS & USER MANUALS
• Mercury

Mercury Netcomm NB16DG Fibre Router User Manual Overview

Summary of Contents

• Page 1: Netcomm NB16DG Fibre Configuration Log into the gateway: Ensure your device is connected to the router (preferably via cable). Open a web browser. Type the following in the address bar at the top: 192.168.20.1. Default Username: admin. Default Password: password. This should then give access to the router’s user interface. If the password is incorrect you will need to factory reset the router by pushing the inset reset button on the back for 10 seconds. How to add correct settings for the Mercury network: Select: Manually set up connection. At the bottom of the page select: Switch to advanced view. From the top menu select: Network setup. From the sub-menu select: Network setup. On the following page set the following: WAN Interface: Ethernet WAN. WAN Type: PPP over Ethernet. Username: (your mercury acct number)@mercurybroadband.co.nz. Password: password. Primary DNS: 202.137.240.39. Secondary DNS: 202.137.240.40. Service Name: Mercury. Assigned IP address: (Leave Blank). MTU: 0. NAT: Enable. Multicast: Disable. IGMP Snooping: Unticked. VLAN Tagging: Ticked - 10.