Smawave SRG821 Ruggedized Router User Guide
FCC Regulations:
FCC RF Radiation Exposure Statement
Step1
Once the router’ s radio module is configured for the SIM card,
it begins the activation/provisioning process and attempts to
connect to the mobile network. This process typically takes
several minutes. A successful connection is indicated by a
solid green NET LED. And the strength of the RF signal can be
indicated by the Signal LEDs in different quantity.
Make sure that the power supply is compatible with the
router.
Step 5 In the Configuration list, change the SSID, such as:
Radio Settings
address bar, and press Enter.
"NR-Router".
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. To comply with FCC RF Exposure
compliance requirements, this grant is applicable to only Mobile
Configurations. The antennas used for the transmitter must be
installed to provide a separation distance of at least 20cm from all
persons and must not be co-located or operating in conjunction
with any other antenna or transmitter.
Step 6
To ensure user data security, it is highly recommended that
you should change the default WiFi password when you login the
CPE at the first time.
Radio Settings
Fails to Login the web management page.
Make sure that the router is started.
Verify that the router is correctly connected to the com-
puter through Wi-Fi or a network cable.
If the problem persists, please contact the authorized
local service suppliers.
Step2 Enter the username and password, and click Login.
Step 7 Click Submit to save the settings.
Step3
After the password is verified, you can login to the web
Indicator Status
Steady on
PWR
Description
Power on
management page.
Off
No power supply
Steady on
Registered to network
The CPE fails to search for the wireless
Off
Not register/SIM LOCK/PIN LOCK
Network searching
network.
NET
Blinking
(500ms interval)
Check if the power supply is connected properly.
Check if the router is placed in an open area .
If the problem persists, please contact the authorized
local service suppliers.
Steady on
Off
WIFI enable
WIFI
WIFI disenable
Indicate the LTE signal，the
stronger signal，the more LEDs on
Steady on
Off
NR-Router
—Reorient or relocate the receiving antenna.
The parameters are restored to default
The default username and password are both admin. Please be
aware: When you login to Web management page, you will see an
un-safe notice beside to the URL bar and this is due to no built-in
SSL Certificate in CPE. However, there's no problem about security
so you may just ignore it.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Signal
No signal
values.
If the router is powered off unexpectedly while being
configured, the parameters may be restored to the default
settings.
Blinking one by one Firmware upgrade
The default setting is Auto-Connect along with full-band
scanning. If users would like to scan any specific bands, then
please select band-lock setting.
—Consult the dealer or an experienced radio/ TV technician for help.
Changes or modifications not expressly approved by the manufacturer
could void the user’s authority to operate the equipment.
After configure the parameters, download the configura-
tion file and restore the desired settings quickly.
Configure the CPE
Login to the website
Configuration of Wi-Fi
Configuration of Radio
The router does not support SIM card hot-plug,
please confirm that the device is powered off when
the SIM card is inserted or removed.
Step 1 Connect the CPE correctly.
FAQs
Step1
Step2
Connect the CPE correctly.
You should use a web browser to access to the web management
page to configure the CPE. The following procedures describe
how to use a PC operates with Windows 7 or above OS and web
browser to connect to the CPE web management page.
Enter the management website.
Step 2
Enter the management website.
Step 3 Choose Advanced Settings → Wi-Fi → WLAN Settings.
Step 4 In the General Settings list, set Wi-Fi Enable or enable
Wi-Fi with the Wi-Fi button.
The POWER indicator does not turn on.
Make sure that the power cable is connected properly
and the router is powered on.
Step3 Choose Advanced Setting → Network → Radio Settings.
Set the connection mode and scan mode.
Step4
7
8
9
10
11
12
13
| General | Details |
|---|---|
| Name | Smawave SRG821 Ruggedized Router User Guide |
| Make | Smawave |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.59 MB |
(1 votes, average: 5.00 out of 5)
Loading...
If you have any questions regarding Smawave SRG821 Ruggedized Router User Guide, please ask here and describe the problem in detail.
SMAWAVE SRP620-B 5G IP67 Ruggedized Router User Guide
SMAWAVE SRE410 LTE CPE Router User Guide
NETGEAR MR6110 M6 5G WiFi 6 Mobile Router User Manual
Maiyuan AX3000W Router Installation Guide
TP-Link T150500-2-DT WiFi Router Instruction Manual
D-Link AX4800 Mesh Wi-Fi 6 Router Installation Guide
TP-Link AX6000 Dual Band WiFi 6 Router User Guide
EnGenius ESG620 Cloud Managed VPN Router User Guide
Acer W6 Predator Connect W6x Dual Band Wi-Fi 6 Router User Manual
TP-Link AC1900 Wireless MU-MIMO Wi-Fi Router Instruction Manual
D-LINK DIR-827 HD 2000 Media Router Installation Guide
amped wireless R10000G High Power Wireless N 600mW Gigabit Router User Guide