Home > VIRTUAL ACCESS > VIRTUAL ACCESS GW1000M Series Router User Manual
VIRTUAL ACCESS GW1000M Series Router User Manual
2: GW1000M Series router hardware
_______________________________________________________________________________________________________
2.10 Inserting a SIM card
1. Ensure the unit is powered off.
2. Hold the SIM 1 card with the chip side facing down and the cut corner front left.
3. Gently push the SIM card into SIM slot 1 until it clicks in.
4. If using SIM 2 then hold the SIM with the cut corner front right
5. Gently push the SIM card into SIM slot 2 until it clicks in.
2.11 Connecting the SIM lock
Connect the SIM lock using the Allen key provided.
2.12 Connecting cables
Connect one end of the Ethernet cable into port A and the other end to your PC or
switch. For information on connecting cables for a vehicle installation, read chapter 4,
‘Installing a router into a vehicle’.
2.13 Connecting the antenna
If you are connecting only one antenna, screw the antenna into the MAIN SMA
connector.
If you are using two antennas, screw the main antenna into the MAIN SMA connector
and the secondary antenna into the AUX SMA connector.
2.14
Installing the GW1000M
You can install the GW1000M in a vehicle or on a wall. To read how to install the
GW1000M in a vehicle read the Chapter ‘Installing the router in a vehicle’.
2.15 Installing the GW1000M on a wall
You can mount the router on a wall using the supplied carrier and suitable mounting
fixtures for the wall type (not supplied). You must not mount it more than 2 metres
above floor level.
2.16 Powering up
The router takes approximately 2 minutes to boot up. During this time, the PWR/CONFIG
LED flashes in a double flash pattern – 2 quick fashes followed by a pause.
Other LEDs display different diagnostic patterns during boot up.
Booting is complete when the PWR/CONFIG LED stops double flashing and stays solid or
flashing steady, indicating the particular running configuration is loaded. Read the
chapter ‘GW1000 LED behaviour’, for PWR/CONFIG LED states.
_______________________________________________________________________________________________________
© Virtual Access 2023
GW1000M Series User Manual
Issue: 2.7
Page 20 of 23
2: GW1000M Series router hardware
_______________________________________________________________________________________________________
2.17 Reset button
The reset button is used to request a system reset.
When you press the reset button the PWR/CONFIG LED will display different patterns
depending on how long you press the button. The flashing patterns will be different for
the 2 flashing phases indicated below. The length of time you hold the reset button will
determine the router behaviour.
Press duration
PWR/CONFIG LED
behaviour
Router behaviour on depress
0-3 seconds
Solid on
Normal reset to running config. No special
LED activity.
Between 3 and 15 seconds
Between 15 and 20 seconds
Between 20 seconds and 30 seconds
Over 30 seconds
Flashing fast
Solid on
Releasing between 3-15 seconds switches
the router back to factory configuration.
Releasing between 15-20 seconds performs
a normal reset to running config.
Flashing slowly
Solid on
Releasing between 20-30 seconds reboots
the router in recovery mode.
Releasing after 30 seconds performs a
normal reset.
Table 4: GW1000M Series router reset behaviour
2.17.1 Recovery mode
Recovery mode is a fail-safe mode where the router can load a default configuration
from the router’s firmware. If your router goes into recovery mode, all config files are
kept intact. After the next reboot, the router will revert to the previous config file.
You can use recovery mode to manipulate the config files but should only be used if all
other configs files are corrupt. If your router has entered recovery mode, contact your
local reseller for access information.
_______________________________________________________________________________________________________
© Virtual Access 2023
GW1000M Series User Manual
Issue: 2.7
Page 21 of 23
| General | Details |
|---|---|
| Name | VIRTUAL ACCESS GW1000M Series Router User Manual |
| Make | VIRTUAL ACCESS |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.58 MB |
(1 votes, average: 5.00 out of 5)
Loading...
If you have any questions regarding VIRTUAL ACCESS GW1000M Series Router User Manual, please ask here and describe the problem in detail.
PRISMXR P1411 Streaming Link Air Bridge WiFi6 Router User Guide
WIND telecom Surf-i TD-LTE 4G Wireless Router User Manual
DIGI WR21-M52A-DE1-TB TransPort WR21 Cellular Router User Guide
MetaBlox Roam MBMAX60 Wi-Fi 6 Active AC Router User Guide
Juniper NETWORKS ACX7024 Cloud Metro Router User Guide
ESUNSTAR AF792 Portable 4G Router User Manual
EE HH10E Smart 4G Hub 2 WiFi Router User Guide
SKYWORTH R6215 Wi-Fi 6 Mesh Router Installation Guide
D-Link DWR-930M 4G LTE Mobile Router Installation Guide
altice UBN2309 XGS-PON Labs Delivers Router Instruction Manual