Anywhere AX50 Series Dual Band Gigabit Wi-Fi 6 Router User Guide
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
⚫
⚫
⚫
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
⚫
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Caution: Any changes or modifications not expressly approved by AX52/AX52e Anywhere Network Node
for compliance could void the user's authority to operate this equipment.
RF Exposure
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This device and its antenna must not be co-located or operating in conjunction with
any other antenna or transmitter.
The antennas used for this transmitter must be installed to provide a separation distance of at least
20 cm from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.”
CMIIT ID
本产品上如有无线电发射设备型号核准代码表示产品符合《中华人民共和国无线电管理
条例》,并获国家无线电管理委员会核发“无线电发射设备型号核准证”。
OFCA
This product in compliance the HKCA 1039 (Issue 6) standards issued by the Hong
Kong Communications Authority.
Warning: The 5.15 to 5.35 GHz band is restricted for indoor use in Hong Kong.
RCM marking on this product represents the product in compliance with AS/NZS
4268 as regulated by Australian Communications and Media Authority (ACMA).
KC marking on this product, if any, represents the product in compliance with the
clause 2, Article 58-2 of Radio Waves Act in Korea.
NCC marking and the NCC certificate number on this product, if any, represent the
product in compliance with the LP0002 (4.7) Low-power Radio-frequency Devices
technical regulations and approved by the National Communications Commission in
Taiwan.
Warning: Deployment in Taiwan shall meet NCC requirements below.
警告
•
應避免影響附近雷達系統之操作。
•
•
高增益指向性天線只得應用於固定式點對點系統。
經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自變
更頻率、加大功率或變更原設計之特性及功能。
•
•
低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,
應立即停用,並改善至無干擾時方得繼續使用。前項合法通信,指依電信法規定作
業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射
性電機設備之干擾。
電磁波曝露量 MPE 標準值為:1 mW/cm2,送測產品實測值為:0.14 mW/cm2。
The RoHS, China RoHS and WEEE markings on this product represent the product is
designed to meet EU Restriction on Hazardous Substances Directive 2011/65/EC,
China environmental declaration with Environment-Friendly Use Period (EFUP), and
the Directive 2002/96EC on Waste of Electrical and Electronic Equipment respectively.
- 3 -
| General | Details |
|---|---|
| Name | Anywhere AX50 Series Dual Band Gigabit Wi-Fi 6 Router User Guide |
| Make | AnyWhere |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.38 MB |
If you have any questions regarding Anywhere AX50 Series Dual Band Gigabit Wi-Fi 6 Router User Guide, please ask here and describe the problem in detail.
























