D-Link DSR-250V2 5-Gigabit Port VPN Router Installation Guide

1

2

3

4

5

6

7

8

Using a Console Connection  

(RJ45-to-DB9 DCE)  

Initially Configure the Device  

The services router software is preinstalled on the  

DSR-250V2 device. When the device is powered  

on, it is ready to be configured. While the device  

has a default factory configuration that allow you  

to initially connect to the device, you must perform  

further configuration for your specific network  

requirements.  

The Services Router provides an serial port that  

enables a connection to a computer or terminal  

for monitoring and configuring the device. This  

port is a RJ-45 connector, implemented as a  

data communication terminal equipment (DCE)  

connection.  

To use the console port connection, you need the  

following equipment:  

Using the WebUI  

To use the WebUI, the workstation from which you  

are managing the device must initially be on the  

same subnetwork as the device.  

1. A terminal or a computer with both a serial port  

and the ability to emulate a terminal.  

2. A RJ45-to-DB9 RS-232 with female connector.  

To access the device with the WebUI:  

(Already included in packing list)  

1. Connect your workstation on the port labeled  

3. If your Laptop or PC doesn’t have RS-232  

connector, a converter is required.  

LAN (1-4), which is pre-allocated to the LAN.  

2. Ensure your workstation is DHCP Client  

enabled or configured with a static IP address  

in the 192.168.10.0/24 subnet.  

Note: DSR-250V2 does not come with RS-232  

converter and these must be purchased separately.  

To establish a console connection:  

3. Log on the Services Router Web Interface The  

default log on information is:  

1. Plug the RJ-45 connector of the supplied  

RJ45-to-DB9 cable directly to the console port  

on the Services Router.  

Username: admin  

Password: Admin$123  

2. Connect the other end of the cable to a terminal  

or to the serial connector of a computer  

running terminal emulation software. Set the  

terminal emulation software as following:  

Baud rate: 115200  

Data bits: 8  

Parity: None  

Stop bits: 1  

Flow control: None  

3. When you have correctly set up the terminal,  

having previously followed the instructions  

in section “Connecting Power and Turn the  

Device On/Off” then switch on your device.  

The boot sequence appears in the terminal.  

Figure 4. WebUI login  

4. Once the boot sequence completes, the  

command prompt is displayed, the device is  

ready to be configured.  

4  D-Link Unified Services Router  

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	D-Link DSR-250V2 5-Gigabit Port VPN Router Installation Guide
Make	D-Link
Language	English
Filetype	PDF (Download)
File size	0.24 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL WI-FI INSTRUCTIONS & USER MANUALS
• D-Link

Questions and Answers (0)

If you have any questions regarding D-Link DSR-250V2 5-Gigabit Port VPN Router Installation Guide, please ask here and describe the problem in detail.