ADVANTECH SL302 SmartStart LTE Router User Manual
SmartStart SL302
5.8.2 Power PWR/IO Connector
Panel socket 4-pin.
Pin number
Signal mark
GND(-)
VCC(+)
IN0
Description
1
2
3
4
Negative pole of DC supply voltage
Positive pole of DC supply voltage (+9 to +36 V DC, 1 A)
Binary input
OUT0
Binary output
Table 6: Connection of PWR / IO connector
Figure 16: PWR / IO connector
Unit has to be supplied by a power supply specified as a Limited Power Source (LPS) accord-
ing to Annex Q of IEC 62368-1:2014. If the power supply/cable provided with device is not
used, always use the cables with minimum wire size (nominal cross section) 0.5 square mm
for power supply.
The power supply for the router must be between +9 V to +36 V DC, with current output
1 A. Protection against reversed polarity without signaling is built into the router. Note: The
protection against reversed polarity is lost if the negative pole is grounded!
The router is awakened after the power supply outage and subsequent renewal.
Figure 17: Circuit example – connection of power supply
The PWR / IO interface is also designed for the processing of binary input and control
(setting) of binary output.
18
| General | Details |
|---|---|
| Name | ADVANTECH SL302 SmartStart LTE Router User Manual |
| Make | Advantech |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.46 MB |
If you have any questions regarding ADVANTECH SL302 SmartStart LTE Router User Manual, please ask here and describe the problem in detail.

ADVANTECH ICR-3200 Cellular Router Instruction Manual

ADVANTECH ICR-2701 Engineering Portal Cellular Router User Guide

ADVANTECH ICR-2531 LTE Router User Manual

advantech ICR-3831 RAILWAY 4G LTE ROUTER & GATEWAY User Guide

ADVANTECH ICR-2431 LTE Router User Manual

ADVANTECH ICR-2041 LTE Router User Manual


























































