SDMC AX3000 Dual Band Mesh Router User Guide
position. Please refer to the following suggestions:
◼ Do not exceed two walls between the primary node and the
secondary node, and the maximum distance should not exceed 20
meters.
(about 80 seconds), indicating that the node's system is starting. After
the start is complete, the description of LED indicator’s status is as
follows.
②
When the power is turned on, the LED indicator is solid red.
primary node but signal
quality is bad
After about 80 seconds, the system starts up and the LED indicator
is flashing green.
③
Continue to observe the LED indicator until it changes from
flashing green to solid green.
If the LED indicator is not solid green. Please re-select a
suitable placement position to obtain the best connection quality.
Node
State
Description
FAQ
◼ Keep away from interference sources such as microwave ovens,
induction cookers, refrigerators, etc.
Q1：The device connected to node cannot access the Internet?
A1：First, observe whether the LED indicator of the primary node is
solid green. If not, please check whether the node's Internet access
mode is set correctly. If it is correct, please contact your network
operator to check whether the home network is normal.
Secondly, observe whether the secondary node is solid green.
If it is not, please change to a more suitable place.
Successfully connected to the
Internet
Solid green
Flashing red
Flashing green
④
◼ Higher from the ground and less obstructions around.
Connecting to the Internet
Connecting to the secondary
node
Primary
◼
Wired device Internet access: please connect to the WAN
ports of all nodes.
◼
Wireless device Internet access: Please connect to the
wireless network marked on the sticker at the bottom of all
nodes. By default, the wireless name/password of all nodes are
the same.
Successfully connected to
primary node and signal
quality is good
Solid green
Q2: How to add new node?
A2: Push Primary or Secondary node’s Mesh button, then push the
new node’s Mesh button. If add success, the LED indicators of the
two nodes change from flashing green to solid green.
Flashing green Connecting to primary node
Failed connected to primary
Flashing red
node
Secondary
LED Indicator status description
After the power is turned on, the LED indicator will be solid red
Q3：How to restore the factory settings of the node?
Solid blue
Successfully connected to
| General | Details |
|---|---|
| Name | SDMC AX3000 Dual Band Mesh Router User Guide |
| Make | SDMC |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.21 MB |
(1 votes, average: 5.00 out of 5)
Loading...
If you have any questions regarding SDMC AX3000 Dual Band Mesh Router User Guide, please ask here and describe the problem in detail.
SDMC NE1611B WiFi Cable Modem Router User Manual
TP-Link VR600 Wireless DSL Modem Router Installation Guide
AT T MF985 Velocity 2 WiFi Hotspot Router Instruction Manual
ASUS RT-BE96U BE19000 Tri Band WiFi Router User Guide
TRENDNET AX1800 Dual Band Wifi 6 Gigabit Dual Wan VPN SMB Router User Guide
NETGEAR AX1800 WiFi 6 Router User Guide
Roam-ON R10 MiFi 4G LTE WiFi Mobile Hotspot Router User Manual
TP-Link Archer AX55 Wi-Fi 6 Router Installation Guide
HITRON CODA-4582 Cable Modem Router User Guide
YESKAMO IPC Router Expand NVR Wifi Area and Strengthen Camera Signal User Guide
TP-Link M7350 4G LTE Mobile Wi-Fi Router Installation Guide