trend T18S-DS 18V Cordless 1-4 Inch Router Instructions
EN - T18S/DS
EN - T18S/DS
Electronic Protection system
• Never force battery pack into charger. Do not
modify battery pack in any way to fit into a non-
compatible charger as battery pack may rupture
causing serious personal injury.
Charging a Battery and Operation
- (Fig. 4 – 4d)
• The battery pack for this tool has been shipped in a
low charge condition to prevent possible problems.
Therefore, you should charge it until the green LED on
the front right hand side of the charger comes on.
Trend Li-Ion tools are designed with an Electronic
Protection System that will protect the battery pack
against overloading, overheating or deep discharge.
Battery Operation
Charge Status
• Charge the battery packs only in Trend chargers.
To display the amount of charge left in the battery, press
the charge level indicator button, (Fig.2). Fig. 2a shows
the relation between the LED indication and charge left.
The tool will automatically turn off if the Electronic
Protection System engages.
• DO NOT splash or immerse in water or other liquids.
• Do not store or use the tool and battery pack
in locations where the temperature may fall
below 4ºC (34ºF) (such as outside sheds or metal
buildings in winter), or reach or exceed 40ºC
(104ºF) (such as outside sheds or metal buildings
in summer).
• NOTE: Batteries will not reach full charge the first
time they are charged. Allow several cycles (operation
followed by recharging) for them to become fully
charged.
Battery Charging Indoors
NOTE: The battery charge level indicator is only an
indication of the charge left on the battery pack. It does
not indicate tool functionality and is subject to variation
based on product components, temperature and end-
user application.
This charger is designed to be used indoors. We do not
recommend that it is used inside your home. Ideally
batteries should be charged on a bench in a workshop,
garage or shed. If the charging operation is to be carried
out in your home the area must be well ventilated and
the charger must be placed on a non combustible
surface ensuring that the ventilation slots are not
blocked
• First read the safety instructions then follow the
charging instructions.
• Do not incinerate the battery pack even if it is
severely damaged or is completely worn out. The
battery pack can explode in a fire. Toxic fumes and
materials are created when lithium-ion battery packs
are burned.
Self-Discharge
• Plug the charger into a standard 230V~50Hz mains
socket outlet, the green LED on the front left hand side
of the charger will illuminate.
A lithium battery can self discharge and lose its stored
charge. Typically it can lose approximately 5% of its
charge in the first month after fully charging (when stored
at room temperature), and then loses it by a further 3%
per month. When stored at higher temperatures the self-
discharge rate will be accelerated.
Wall Mounting
• Do not allow the cable to become knotted or kinked.
These chargers are designed to be wall mountable or to
sit upright on a table or work surface. If wall mounting,
locate the charger within reach of an electrical outlet,
and away from a corner or other obstructions which
may impede air flow. Use the back of the charger as a
template for the location of the mounting screws on the
wall. Mount the charger securely using suitable fixings
depending on wall type, a head diameter of 7 – 9mm
and length of 25mm is recommended. Leave a suitable
length of the screw exposed to allow the charger to be
fitted. Align the slots on the back of the charger with the
exposed screws and fully engage them in the slots.
• If battery contents come into contact with the
skin, immediately wash area with mild soap and
water. If battery liquid gets into the eye, rinse water
over the open eye for 15 minutes or until irritation
ceases. If medical attention is needed, the battery
electrolyte is composed of a mixture of liquid organic
carbonates and lithium salts.
• Place the battery pack into the charger base. (Note
the battery has raised ribs which allows it to fit into
the charger only one way). Time the charge 32, 48, 54
minutes only.
Transportation
• The red LED on the front right hand side of the charger
will illuminate to indicate charging is in progress. A
green LED will illuminate when the battery is fully
charged.
WARNING: Fire hazard. Transporting
batteries can possibly cause fire if the battery terminals
inadvertently come in contact with conductive materials.
When transporting batteries, make sure that the battery
terminals are protected and well insulated from materials
that could contact them and cause a short circuit.
• Contents of opened battery cells may cause
respiratory irritation. Provide fresh air. If symptoms
persists, seek medical attention.
• Unplug the charger when not in use and store it in a
suitable storage cabinet.
• Avoid charging your battery in freezing conditions as
charging power will not be sufficient.
NOTE: Lithium-ion batteries should not be put in
checked baggage.
WARNING: Burn hazard. Battery liquid
Charger Cleaning Instructions
• When charging more than one battery pack in
succession allow at least 30 minutes for the charger to
cool down before charging an additional battery.
may be flammable if exposed to spark or flame.
Trend batteries comply with all applicable shipping
regulations as prescribed by industry and legal standards
which include UN Recommendations on the Transport
of Dangerous Goods; International Air Transport
Association (IATA) Dangerous Goods Regulations,
International Maritime Dangerous Goods (IMDG)
Regulations, and the European Agreement Concerning
The International Carriage of Dangerous Goods by
Road (ADR). Lithium-ion cells and batteries have been
tested to section 38.3 of the UN Recommendations on
the Transport of Dangerous Goods Manual of Tests and
Criteria.
WARNING: Shock hazard. Disconnect the
charger from the AC outlet before cleaning. Dirt and
grease may be removed from the exterior of the charger
using a cloth or soft non-metallic brush. Do not use
water or any cleaning solutions. Never let any liquid get
inside the tool; never immerse any part of the tool into
a liquid.
WARNING: Never attempt to open the
battery pack for any reason. If battery pack case is
cracked or damaged, do not insert into charger. Do
not crush, drop or damage battery pack. Do not use a
battery pack or charger that has received a sharp blow,
been dropped, run over or damaged in any way (i.e.,
pierced with a nail, hit with a hammer, stepped on).
Electric shock or electrocution may result. Damaged
battery packs should be returned to service centre for
recycling.
• Always remove the battery pack and store it safely
when the tool is not in use.
CAUTION: If at any point during the charging
process none of the LEDs are lit, remove the battery
pack from the charger to avoid damaging the product.
DO NOT insert another battery.
Battery Packs
Cooling System
The charger is equipped with an internal fan designed
to cool the charger. Never operate the charger if the
fan does not operate properly or if ventilation slots are
blocked. Do not permit foreign objects to enter the
interior of the charger.
Important Safety Instructions for All Battery Packs
In most instances, shipping a Trend battery pack will
be excepted from being classified as a fully regulated
Class 9 Hazardous Material. In general, only shipments
containing a lithium-ion battery with an energy rating
greater than 100 Watt Hours (Wh) will require being
shipped as fully regulated Class 9.
When ordering replacement battery packs, be sure to
include product reference and voltage.
WARNING: Fire hazard. Do not store or
carry the battery pack so that metal objects can
contact exposed battery terminals. For example,
do not place the battery pack in aprons, pockets, tool
boxes, product kit boxes, drawers, etc., with loose nails,
screws, keys, etc.
The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read
the safety instructions below. Then follow charging
procedures outlined.
Hot/cold Pack Delay
When the charger detects a battery pack that is too
hot or too cold, it automatically starts a Hot/Cold Pack
Delay, suspending charging until the battery pack has
reached an appropriate temperature. The charger then
automatically switches to the pack charging mode. This
feature ensures maximum battery pack life.
All lithium-ion batteries have the Watt Hour rating
marked on the pack. Furthermore, due to regulation
complexities, Trend does not recommend air shipping
lithium-ion battery packs alone regardless of Watt Hour
rating. Shipments of tools with batteries (combo kits) can
be air shipped as excepted if the Watt Hour rating of the
battery pack is no greater than 100 Whr.
READ ALL INSTRUCTIONS
CAUTION: When not in use, place tool on its
side on a stable surface where it will not cause a tripping
or falling hazard. Some tools with large battery packs
will stand upright on the battery pack but may be easily
knocked over.
• Do not charge or use battery in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Inserting or
removing the battery from the charger may ignite the
dust or fumes.
-10-
-11-
| General | Details |
|---|---|
| Name | trend T18S-DS 18V Cordless 1-4 Inch Router Instructions |
| Make | trend |
| Language | English |
| Filetype | PDF (Download) |
| File size | 1.09 MB |
(1 votes, average: 5.00 out of 5)
Loading...
If you have any questions regarding trend T18S-DS 18V Cordless 1-4 Inch Router Instructions, please ask here and describe the problem in detail.
trend T1ETS Electric Trim Router Instruction Manual
trend Router Cutter Safety Instructions
trend T8EK Electric Router Instruction Manual
Cudy AX3000 Wi-Fi 6 Mesh Router Installation Guide
GEWISS GW A9707 KNX/IP Router Installation Guide
LANCOM SYSTEMS 1790-4G+ High-Performance VPN Router Installation Guide
Milesight UF51 5G CPE Router User Guide
TP-Link VR2100v Wireless Mu Mimo VDSL ADSL Modem Router Instruction Manual
CalAmp LMU-5541 Telematics Router Installation Guide
levelone WGR-8031 AC1200 Dual Band Wireless Gigabit Router Owner’s Manual
SDMC NE1611B WiFi Cable Modem Router User Manual
TP-Link 7106508102 Deco Router Installation Guide
D-Link DIR-2660 AC2600 Smart Mesh Wifi Router Installation Guide