Home > ELTEC > ELTEC CYBOX RT 2-A Wireless Automotive Router Installation Guide

ELTEC CYBOX RT 2-A Wireless Automotive Router Installation Guide

CYBOX RT 2-A  
3.5  
RESET SWITCH  
The CyBox RT 2-A is equipped with a hidden reset switch behind the front panel, which is located beside  
the service cover. The button is accessible with a straightened paper clip pushed through the little hole on  
the front panel. The effect of pressing the reset switch depends on the duration of its activation, as  
indicated in Table 10 below. The time response is valid only if the device has completly booted (after  
approx. 1 min). While the device is booting or executing U-Boot, pushing the button will always reset the  
device.  
The following table describes the functions of the reset switch.  
HOLD TIME  
< 2 seconds  
2-5 seconds  
> 5 seconds  
FAIL LED BEHAVIOR ACTION  
Off  
Reset after release  
Off  
No action  
Green blinking  
Remove custom configuration then reset  
Table 10  
Reset Switch Behavior  
3.6  
SIM CARDS  
The CyBox RT 2-A provides 2 SIM slots per LTE modem. Only one slot per modem can be active at any time.  
To install SIM cards the service cover has to be removed using a suitable torx 10 screwdriver. After installing  
the SIM cards the service cover must be closed and the screws tightened to a maximum torque of 0.55 Nm.  
The indexing of SIM slots is software dependent and can be selected via an SNMP command or using the  
web interface.  
Note:  
Switching between SIM slots takes about 30 seconds, slot 1 being preselected at power up.  
If you plan to use only one SIM card for a given LTE modem it is advisable to use slot 1 to  
avoid slot switching delay during booting.  
The drawing in Figure 5 shows the SIM slot assignment per modem.  
Figure 5 SIM Slot Assignment per Modem  
Important:  
Do not change the SIM cards when the device is powered.  
8
       
GeneralDetails
NameELTEC CYBOX RT 2-A Wireless Automotive Router Installation Guide
MakeELTEC
LanguageEnglish
FiletypePDF (Download)
File size0.29 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

If you have any questions regarding ELTEC CYBOX RT 2-A Wireless Automotive Router Installation Guide, please ask here and describe the problem in detail.

Leave a Reply

Your email address will not be published. Required fields are marked *

10 − 6 =

ELTEC CYBOX RT 2-A Automotive Wireless Router Instructions
ELTEC CYBOX RT 2-A Automotive Wireless Router Instructions

ELTEC CYBOX RT 2-A Wireless Automotive Router Installation Guide