ELTEC CYBOX RT 2-A Wireless Automotive Router Installation Guide

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

CYBOX RT 2-A  

3.2  

POWER SUPPLY  

3.2.1 POWER INPUT  

The CyBox RT 2-A can be powered by a DC power source connected to the internal power supply and I/O  

connector, shown in Table 1 . The nominal input voltage can vary between 12 V and 24 VDC.  

3.3  

FRONT AND BACK PANEL DISTRIBUTION  

3.3.1 FRONT PANEL SERVICE COVER  

The CyBox RT 2-A is equipped with a USB 2.0 Type A service port and 4 SIM slots, which are located behind  

the service cover as shown in Figure 3 and described in Table 4. The USB port can be used to attach a  

memory device to update the firmware or to configure the device. The service cover is secured with 2 torx  

screws.  

Note:  

The USB port is a dedicated maintenance port. It is not designed to be used while the  

device is in operation inside rolling stock equipment.  

The figure below provides an overview of the front panel.  

Figure 3  

Front Panel Overview  

LABEL  

LTE 1  

PORT  

DESCRIPTION  

SIM 1 / SIM 2  

2 SIM slots for LTE module 1 are available. SIM slot 1  

is the lower one, SIM slot 2 is the upper one as  

indicated on the front panel.  

LTE 2  

SIM 1 / SIM 2  

2 SIM slots for LTE module 2 are available. SIM slot 1  

is the lower one, SIM slot 2 is the upper one as  

indicated on the front panel.  

USB  

USB 2.0  

Type A jack (female)  

Table 4  

Front Panel Service Cover  

5

           

(1 votes, average: 5.00 out of 5)

Loading...

• ALL WI-FI INSTRUCTIONS & USER MANUALS
• ELTEC

Questions and Answers (0)

If you have any questions regarding ELTEC CYBOX RT 2-A Wireless Automotive Router Installation Guide, please ask here and describe the problem in detail.