inhandgo CR202 InHand Networks Portable 4G Router User Manual

To restore to default settings via the reset button, please perform the following steps:  

1. Press the RESET button immediately after power on the device.  

2. When System LED is steady on, release RESET button, system LED will blink, and press the  

RESET button again.  

4. When System LED blinks slowly, release the RESET button. The device has been restored to  

default settings and will start up normally later.  

3

II. INSTALLATION  

2.1 PREPARATIPNS  

Precautions:  

Please be sure there is 3G/4G network coverage. Avoid direct sunlight, away from heat source or  

strong electromagnetic interference. First installation shall be done under direction of the engineer  

recognized by InHand Networks.  

•

•

•

•

1 PC  

OS: Windows 7, Windows 10, Windows 11  

Ethernet port: At least one (10M/100M)  

1 SIM card:  

Ensure the card is enabled with data service and its service is not suspended  

because of an overdue charge.  

Power supply:  

5V/2A Type-C interface  

Internal battery  

Fixation:  

Please place CR202 on flat level and have it installed in an environment with small  

vibrational frequency.  

The device shall be installed and operated in powered-off status!  

2.2 INSTALLATION  

2.2.1 SIM/UIM Card  

CR202 supports single nano SIM card or eSIM. Please install the SIM card like below if use nano  

4

       

(1 votes, average: 5.00 out of 5)

Loading...

• ALL WI-FI INSTRUCTIONS & USER MANUALS
• inhandgo

Questions and Answers (0)

If you have any questions regarding inhandgo CR202 InHand Networks Portable 4G Router User Manual, please ask here and describe the problem in detail.