LANCOM SYSTEMS LANCOM 1790-4G Plus High-Performance VPN Router Instruction Manual

1

Hardware  

LANCOM 1790-4G+  

Gigabit Ethernet 10/100/1000  

Power supply  

12 V DC, external power adapter (230 V); bayonet connector to secure against discon-  

nection  

Power consumption Max. ca. 9 W  

Ant 2  

Ant 1  

Environment  

Housing  

Temperature range 0–40 °C; humidity 0–95 %; non-condensing  

Robust synthetic housing, rear connectors, ready for wall mounting, Kensington lock;  

measures 210 x 45 x 140 mm (W x H x D)  

➀

➁

➂

➃

➄

➅

➆

WAN  

ETH 3  

ETH 2  

ETH 1  

Config (Com)  

USB  

DC 12 V  

Number of fans  

Interfaces  

1 quiet fan  

➀ Power  

➃ ETH  

4G: Ant 1, Ant 2  

Two SMA connectors for the supplied dipole rod antennas (LTE, UMTS), compatible  

LANCOM AirLancer antennas for 4G or 3G, or from other manufacturers. Please re-  

spect the restrictions which apply in your country when setting up an antenna system  

(in particular the antenna gain and transmission power).  

Off  

Device switched off  

Off  

No networking device attached  

➀

➁

➂

➃

➄

➅

➆

➀

Green, permanently* Device operational, resp. device  

paired / claimed and LANCOM  

Management Cloud (LMC)  

Green, permanently Connection to network device ope-  

rational, no data traffic  

WAN  

ETH  

10 / 100 / 1000 Mbps Gigabit Ethernet  

Green, flickering  

Data transmission  

3 individual 10 / 100 / 1000 Mbps Gigabit Ethernet ports; ex-factory operation as  

switch. The ports can be electrically disabled in the LCOS configuration and support  

energy saving functionality as per IEEE 802.3az.  

accessible  

Hardware Quick Reference  

➄ 4G  

Red / green blinking Configuration password not set.  

Without a configuration password,  

the configuration data in the device  

is unprotected.  

Off  

Cellular interface disabled  

LTE / 4G antennas  

Connect the two supplied cellular antennas to the  

connectors Ant 1 and Ant 2.  

Configuration interface  

Configuring the device via the serial interface  

requires a serial configuration cable (available as an  

accessory).  

➀

➁

➄

USB  

USB 2.0 hi-speed host port for connecting USB printers (USB print server),  

serial devices (COM-port server) or USB drives (FAT file system)  

Green, permanently Connection to cellular network active  

LANCOM 1790-4G+  

Green, flickering  

Cellular data transfer  

Config (Com) /  

V.24  

Serial configuration interface/COM-port (8-pin mini-DIN): 9,600 - 115,200 baud,  

suitable for optional connection of analog/GPRS modems. Supports internal COM-port  

server and provides transparent asynchronous serial-data transfer via TCP.  

Red blinking  

Charge or time limit reached  

Orange,  

permanently  

Logon to cellular network successful  

1x green inverse  

blinking*  

Connection to the LMC active,  

pairing OK, device not claimed  

WAN interface  

Connect the WAN interface to your WAN modem  

using the enclosed ethernet cable with the dark green  

connectors.  

USB interface  

You can use the USB interface to connect a USB  

printer or a USB memory stick.  

➅

➆

Orange, blinking  

Red, permanently  

Logging on to cellular network  

WAN protocols  

2x green inverse  

blinking*  

Pairing error, resp. LMC activation  

code not available  

Hardware error/module unavailable  

Ethernet  

PPPoE, PPPoA, IPoA, Multi-PPPoE, ML-PPP, PPTP (PAC or PNS) and IPoE (with or  

without DHCP), RIP-1, RIP-2, VLAN  

3x green inverse  

blinking*  

LMC not accessible, resp.  

communication error  

Red / green, blinking SIM card error (PIN)  

Red / orange,  

blinking  

Uploading module firmware  

Package content  

Ethernet interfaces  

Power  

➂

➃

➁ Online  

Use the cable with the green-colored connectors to  

connect one of the interfaces ETH 1 to ETH 3 to your PC  

or a LAN switch.  

After connecting the cable to the device, turn the  

bayonet connector 90° clockwise until it clicks into  

place.  

Cable  

1 Ethernet cable, 3 m (kiwi colored connectors)  

➅ VPN  

Off  

WAN connection inactive  

Antennas  

Power adapter  

2 LTE / 4G antennas  

Green, blinking  

WAN connection is established (e.g.  

PPP negotiation)  

Off  

VPN connection inactive  

External power adapter, 12 V / 2 A DC/S, barrel connector 2.1 / 5.5 mm bayonet,  

LANCOM item no. 111303 (not for WW devices)  

Use only the supplied power adapter.  

Green, permanently VPN connection active  

SIM card slot (bottom side of the device)  

Green, permanently WAN connection active  

Green, flashing  

VPN connecting  

Release the SIM-card holder and lever it upwards. Slide  

the SIM card into the guide slot of the SIM-card holder.  

Press the holder down until it clicks into place.  

Red, permanently  

WAN connection error  

➆ Reset  

➂ WAN  

Reset button  

Operated e.g. with a paper clip  

short press: Restart the device  

long press: Reset the device  

Off  

Interface deactivated  

Orange, blinking  

Synchronization with the modem  

Orange,  

permanently  

Synchronization with the modem  

successful  

Green, permanently WAN connection established  

Green, flickering  

WAN data transmission  

Red / orange,  

blinking  

Hardware error, ext. modem  

Before initial startup, please make sure to take notice of the information  

regarding the intended use in the enclosed installation guide!  

Please observe the following when setting up the device  

→The power plug of the device must be freely accessible.  

i

→For devices to be operated on the desktop, please attach the adhesive rubber footpads  

→Do not rest any objects on top of the device  

Operate the device only with a professionally installed power supply at a  

nearby power socket that is freely accessible at all times.  

*) The additional power LED statuses are displayed in 5-seconds rotation if the device is configured to be managed by the LANCOM Manage-  

ment Cloud.  

Hereby, LANCOM Systems GmbH | Adenauerstrasse 20/B2 | D-52146 Wuerselen, declares that this device is in compliance  

with Directives 2014/30/EU, 2014/53/EU, 2014/35/EU, 2011/65/EU, and Regulation (EC) No. 1907/2006.  

The full text of the EU Declaration of Conformity is available at the following Internet address: www.lancom-systems.com/doc  

→Keep all ventilation slots on the side of the device clear of obstruction  

→In case of wall mounting, use the drilling template as supplied  

This product contains separate open-source software components which are subject to their own licenses, in particular the General Public  

License (GPL). The license information for the device firmware (LCOS) is available on the device‘s WEBconfig interface under “Extras > License  

information“. If the respective license demands, the source files for the corresponding software components will be made available on a down-  

load server upon request.  

Cloud-ready  

→Rack installation with the optional LANCOM Rack Mount (separately available)  

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	LANCOM SYSTEMS LANCOM 1790-4G Plus High-Performance VPN Router Instruction Manual
Make	LANCOM SYSTEMS
Language	English
Filetype	PDF (Download)
File size	0.08 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL WI-FI INSTRUCTIONS & USER MANUALS
• LANCOM SYSTEMS

Questions and Answers (0)

If you have any questions regarding LANCOM SYSTEMS LANCOM 1790-4G Plus High-Performance VPN Router Instruction Manual, please ask here and describe the problem in detail.