Home > CalAmp > CalAmp LMU-5541 Telematics Router Installation Guide

CalAmp LMU-5541 Telematics Router Installation Guide

9/28/23, 4:30 PM  
LMU-5541 Hardware & Installation Guide - PULS Wiki  
Take an Ethernet cable and connect one end to the LMU-5541™ RJ-45 connector and the other end to the maintenance computer.  
Launch the terminal emulation program.  
Power up the LMU-5541™.  
Type: AT#ESN? <Enter>  
Write down the ESN of the unit.  
Remove power from the LMU-5541™.  
8.3 Maintenance computer network setup  
Change the IP settings on the maintenance computer to match the subnet of the LMU-5541™  
Go to Control Panel → Network and Internet → Network and Sharing Center → Change adaptor settings → Local Area Connection → Properties → Internet  
Protocol Version 4 (TCP/IPv4) → Properties →  
Select “Use the following IP address:”  
Enter the following IP settings:  
Ethernet IP address = 192.168.1.189  
Subnet mask = 255.255.255.0  
Default gateway = 192.168.1.55  
Select OK  
Ensure WiFi is disabled on the maintenance computer.  
8.4 Programming the IMX processor  
Apply power to the LMU-5541™, then view the terminal emulation screen.  
Enter <B> to break the u-boot.  
Net: FEC [PRIME]  
Normal Boot  
Hit 'B' to stop autoboot: 0  
LMU5541-Boot >  
The command prompt “LMU-5541-Boot >” will appear.  
Type: nand erase.chip <enter>  
LMU5541-Boot > nand erase.chip  
26/29  
   
GeneralDetails
NameCalAmp LMU-5541 Telematics Router Installation Guide
MakeCalAmp
LanguageEnglish
FiletypePDF (Download)
File size0.5 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

If you have any questions regarding CalAmp LMU-5541 Telematics Router Installation Guide, please ask here and describe the problem in detail.

Leave a Reply

Your email address will not be published. Required fields are marked *

two + 7 =

CalAmp LMU-5541 Telematics Router Installation Guide