Home > CalAmp > CalAmp LMU-5541 Telematics Router Installation Guide

CalAmp LMU-5541 Telematics Router Installation Guide

9/28/23, 4:30 PM  
When completed, “LMU5541-Boot >” will appear.  
LMU-5541 Hardware & Installation Guide - PULS Wiki  
NAND erase.chip: device 0 whole chip  
Erasing at 0x1ffe0000 -- 100% complete.  
OK  
LMU5541-Boot >  
8.5 USB driver installation  
If the USB driver has been previously installed, skip the USB driver installation.  
Power cycle the unit.  
If the USB driver has never been installed, a pop-up window will appear → Driver Software Installation. Proceed with the driver install.  
Upon completion, it will indicate USB Input Device Installed.  
8.6 Firmware update  
Remove power from the LMU-5541™  
Remove the top cover of the LMU-5541™  
Connect the 4-pin connector of 5C940 into the 4-pin header located on the board at J25. The red stripe of 5C940 is placed facing towards the closest edge of the  
board.  
Connect the 5-pin connector of the serial adaptor cable 5C940 to the 5-pin connector of the serial cable 134364-SER.  
Connect the DB-9 connector of 134364-SER to the serial port or serial adaptor connected to the maintenance computer.  
Power up the LMU-5541™  
Launch the TFTP32 or TFTP64 server.  
For the Current Directory window, Browse for Directory C:\tftpboot  
For the Server interface window, select 192.168.1.189  
On the maintenance computer, open the command prompt by searching for CMD.EXE followed by <enter>  
Type: cd c:\tftpboot  
27/29  
   
GeneralDetails
NameCalAmp LMU-5541 Telematics Router Installation Guide
MakeCalAmp
LanguageEnglish
FiletypePDF (Download)
File size0.5 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

If you have any questions regarding CalAmp LMU-5541 Telematics Router Installation Guide, please ask here and describe the problem in detail.

Leave a Reply

Your email address will not be published. Required fields are marked *

3 × three =

CalAmp LMU-5541 Telematics Router Installation Guide