Home > VIMAR > VIMAR 01507 By me KNX Router Instruction Manual

VIMAR 01507 By me KNX Router Instruction Manual

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

BUILDING AUTOMATION

Front-end Web

7. Front-end Web

The front-end Web can be used to read the actual parameters of device 01507 (HTTP port, IP address, MAC address, etc.) to update its firmware. To identify a specific device

01507 in a KNX network, the programming LED/remote programming mode can be turned on and off without pressing the programming button on the device.

To return to the normal operation start mode, perform the ﬁrmware update procedure, then cancel it or wait 10 minutes until the automatic time-out.

7.1 Protecting the front-end Web of 01507

The front-end Web can be used to perform ﬁrmware updates remotely, for the control functions and to read the device settings. To guarantee total protection of an

installation, the front-end Web must be set to "not available" during runtime operation.

To use the remote functions of the front-end Web when the security function is active, it must be set to “available with all functions”.

If the front-end Web is set to “status display only”, the remote control functions (programming mode activation, tunnelling setting) and the updating function are disabled.

Information read only is available.

To guarantee the complete protection of a protected installation, the availability of the front-end Web must be set to “web front-end not available” which is the default

value.

For effective protection, we strongly advise the use of the “available with all functions” option as your permanent setting.

7.2 Accessing the front-end Web of router 01507

You can access the front-end Web of 01507 in two ways. You can access it directly from Windows Explorer or from a web browser. To access via web browser, you need

to know the IP address or the MAC address and the HTTP port. Below is a description of how to use the IP address or the MAC address in the browser address bar.

You need to use the correct HTTP port to access from a web browser.

The value of the HTTP port is 8080 (non-editable).

7.2.1 With the MAC address

When NetBIOS is installed (by default setting in Windows systems), the MAC address can be used. It is printed on the label afﬁxed to the side of the 01507 device

casing (which is also listed in the interfaces identiﬁed by ETS). Due to the name resolution, the communication must be established according to the Host name.

The activation of NetBIOS is required to do this.

Use the MAC address in format AA-BB-CC-XX-YY-ZZ and the HTTP port set by default to be entered in the browser address bar as speciﬁed below, without the

brackets:

http://knx-iprt-[XXYYZZ]:[HTTP port]/

Example:

the label on the side of the 01507 device casing shows the MAC address D0-76-50-11-22-33 and the HTTP port is 8080. Enter “http://knx-iprt-112233:8080/”

in the browser address bar.