Home > VIMAR > VIMAR 01507 By me KNX Router Instruction Manual

VIMAR 01507 By me KNX Router Instruction Manual

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

BUILDING AUTOMATION

System Requirements - Product description

1. System Requirements

To create the network system, make sure all the devices (switch, router, firewall, etc.) are configured in such a way as to allow the passage of multicast messages the device

sends on IP. We recommend you involve an IT manager to make sure the KNX/By-me system can operate in the IP solution of the connections.

2. Product description

The By-me/KNX router enables communication between parts of a system comprising By-me devices, grouped together within an “island”, with a system comprising KNX

devices. The messages are transmitted in both directions according to criteria which define the correspondence of the communication objects belonging to the specific

domains. The router allows up to 500 routing rules. Each rule is specified by the By-me group address, by the KNX address, by the direction of communication (from KNX

to By-me; from By-me to KNX; both) and by the type of information exchanged (1 bit, 2 bit, …).

The device is equipped with a TP terminal for connection to the By-me BUS, an Ethernet connector and a front push button for configuration via ETS. The power supply is

provided by the By-me BUS.

Router 01507 conforms to the KNX Secure requirements on the datapoints defined in the routing table. A datapoint on the KNX side can be defined for the heartbeat signal.

2.1 Front view of the device

A: Ethernet KNX over IP line connector

B: Ethernet KNX over IP line status LED

C: By-me BUS line status LED

D: Traffic on Ethernet KNX over IP line LED

01507

E: Traffic on By-me BUS line LED

ROUTER IP KNX

F: GA LED

State

G: PA LED

H: Reset push button