Home > VIMAR > VIMAR 01507 By me KNX Router Instruction Manual

VIMAR 01507 By me KNX Router Instruction Manual

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

BUILDING AUTOMATION

Front-end Web

7.5 Special functions

7.5.1 IP ﬁrmware update request

Press the H button followed by button L on router 01507 (steps 1 and 2 in Table 8); then activate “request update” to enter boot mode. This displays ”Status:

update authorised”.

Table 8: Activating the ﬁrmware update

Step

Firmware update

Brief press of the programming button

Brief press of the function button and page refresh

Click on “request update” in the front-end Web

The By-me BUS line status LED (C) is ﬂashing green

The ﬁrmware ﬁle can be selected

The device restarts

7.5.2 Updating the IP ﬁrmware

In the Update screen of device 01507 you can update the ﬁrmware via IP, or the Ethernet network. The following steps describe the complete remote updating

procedure. During the process, device 01507 enters boot mode. So LEDs D, E, F and G light up as described in Table 5: LED status for ﬁrmware updating

If boot mode is already active, only follow the instructions of the front-end Web from step 3 to 5 (update, request update).

To quit boot mode, access the Update screen on the front-end Web. You can then complete the ﬁrmware updating, as described in steps 1 to 5, or suspend the

ﬁrmware updating by clicking on the “Abort” button (see step 5). Next, device 01507 is restarted and resumes normal operation.

Step 1: Open the Update screen on the front-end Web.