COMCAST CGA4332COM Advanced WiFi Gateway Router User Guide

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

33

34

35

36

37

38

39

40

41

42

43

44

45

46

47

48

49

50

51

CBR2 CGA4332COM - User Guide  

SAFETY INSTRUCTIONS AND  

REGULATORY NOTICES  

Before you start installation or use of this product, carefully read theseinstructions!  

2 of 51  

CBR2 CGA4332COM - User Guide  

To reduce the risk of electric shock, do not disassemble this product. None  

of its internal parts are user-replaceable; therefore, there is no reason to  

access the interior. Opening or removing covers may expose you to  

dangerous voltages. Incorrect reassembly could cause electric shock if the  

appliance is subsequently used.  

If service or repair work is required, please contact a qualified service  

representative.  

Damage requiring service  

Unplug this product from the wall outlet and refer servicing to qualified  

service personnel under the following conditions:  

When using this product, always follow the basic safety precautions to  

reduce the risk of fire, electric shock and injury to persons, including the  

following:  

.

Always install the product as described in the documentation  

that is included with your product.  

.

Avoid using this product during an electrical storm. There may  

be a remote risk of electric shock from lightning.  

.

.

.

.

.

.

.

.

When the power supply or its plug aredamaged.  

When the attached cords are damaged orfrayed.  

If liquid has been spilled into the product.  

If the product has been exposed to rain or water.  

If the product does not operate normally.  

If the product has been dropped or damaged in any way.  

There are noticeable signs of overheating.  

If the product exhibits a distinct change in performance.  

Warranty Information  

Unless express and prior approval by Technicolor in writing, you may not:  

.

Disassemble, de-compile, reverse engineer, trace or otherwise  

analyze the equipment, its content, operation, or functionality, or  

otherwise attempt to derive source code (or the underlying ideas,  

algorithms, structure or organization) from the equipment, or from any  

other information provided by Technicolor, except to the extent that this  

restriction is expressly prohibited by local law.  

Immediately disconnect the product if you notice it giving off a smell of  

burning or smoke. Under no circumstances must you open the equipment  

yourself; you run the risk of electrocution.  

.

Copy, rent, loan, re-sell, sub-license, or otherwise transfer or distribute  

the equipment to others.  

Regulatory information  

.

.

Modify, adapt or create a derivative work of the equipment.  

Remove from any copies of the equipment any product identification,  

copyright or other notices.  

You must install and use this device in strict accordance with the  

manufacturer's instructions as described in the user documentation included  

with your product.  

Before you start installation or use of this product, carefully read the contents  

of this document for device specific constraints or rules that may apply in the  

country in which you want to use this product.  

In some situations or environments, the use of wireless devices may be  

restricted by the proprietor of the building or responsible representatives of  

the organization.  

If you are uncertain of the policy that applies on the use of wireless  

equipment in a specific organization or environment (e.g. airports), you are  

encouraged to ask for authorization to use this device prior to turning on the  

equipment.  

.

Disseminate performance information or analysis (including, without  

limitation, benchmarks) from any source relating to theequipment.  

Such acts not expressly approved by Technicolor will result in the loss of  

product warranty and may invalidate the user's authority to operate this  

equipment in accordance with FCC Rules.  

Technicolor disclaims all responsibility in the event of use that does not  

comply with the present instructions.  

Safety instructions  

Climatic conditions  

This product:  

Technicolor is not responsible for any radio or television interference caused  

by unauthorized modification of the device, or the substitution or attachment  

of connecting cables and equipment other than specified by Technicolor. The  

correction of interference caused by such unauthorized modification,  

substitution or attachment will be the responsibility of the user. Technicolor  

and its authorized resellers or distributors are not liable for any damage or  

violation of government regulations that may arise from failing to comply with  

these guidelines.  

฀ Is intended for in-house stationary desktop use; the maximum ambient  

temperature may not exceed 40°C (104°F).  

฀ Must not be mounted in a location exposed to direct or excessive solar  

and/or heat radiation.  

฀ Must not be exposed to heat trap conditions and must not be subjected to  

water or condensation. Batteries (battery pack or batteries installed) shall not  

be exposed to excessive heat such as sunshine, fire or thelike.  

฀ Must be installed in a Pollution Degree 2 environment (Environment where  

there is no pollution or only dry, nonconductive pollution).  

Cleaning  

Unplug this product from the wall socket and computer before cleaning. Do  

not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.  

Water and moisture  

Do not use this product near water, for example near a bathtub, washbowl,  

kitchen sink, laundry tub, in a wet basement or near a swimming pool.  

Transition of the product from a cold environment to a hot one may cause  

condensation on some of its internal parts. Allow it to dry by itself before re-  

starting the product.  

Secure handling and disposal of used batteries  

NOTE: Only use the battery qualified for this equipment. Remember to  

dispose batteries properly according to local regulation, i.e. at a battery  

collection point. Batteries may not be disposed with domestic waste.  

Interface classifications  

North America - United States of America  

Important safety instructions  

.

The cable distribution system should be grounded (earthed) in  

accordance with ANSI/ NFPA 70, the National Electrical Code (NEC),  

in particular Section 820,93, Grounding of outer Conductive Shield of  

a Coaxial Cable.  

.

.

Leave 5 to 8 cm (2 to 3 inches) around the product to ensure proper  

ventilation to it.  

Never push objects through the openings in this product.  

Federal Communications Commission (FCC) radio frequency  

interference statement  

This equipment has been tested and found to comply with the limits for a  

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits  

are designed to provide reasonable protection against harmful interference  

in a residential installation. This equipment generates, uses and can radiate  

radio frequency energy and, if not installed and used in accordance with the  

instructions, may cause harmful interference to radio communications.  

However, there is no guarantee that interference will not occur in a particular  

installation. If this equipment does cause harmful interference to radio or  

television reception, which can be determined by turning the equipment off  

and on, the user is encouraged to try to correct the interference by one or  

more of the following measures:  

The external interfaces of the product are classified as follows:  

.

.

.

Phone: TNV circuit, not subjected to over voltages(TNV-2)  

Cable, MoCA, RF: TNV circuit subject to over voltages(TNV-1)  

All other interface ports (e.g., Ethernet, USB, etc.), including the low  

voltage power input from the AC mains power supply: SELVcircuits.  

Electrical powering  

The powering of the product must adhere to the power specifications  

indicated on the marking labels.  

.

.

.

Reorient or relocate the receiving antenna.  

USB  

Increase the separation between the equipment and receiver.  

Connect the equipment into an outlet on a circuit different from that to  

which the receiver is connected.  

The device is to be connected to an identified USB port complying with the  

requirements of a Limited Power Source.  

Accessibility  

The plug on the power supply cord serves as disconnect device. Be sure that  

the power socket outlet you plug the power cord into is easily accessible and  

located as close to the equipment as possible.  

Overloading  

.

Consult the dealer or an experienced radio/TV technician forhelp.  

Do not overload main supply socket outlets and extension cords as this  

increases the risk of fire or electric shock.  

Servicing  

This device complies with Part 15 of the FCC Rules.  

Operation is subject to the following two conditions:  

3 of 51  

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	COMCAST CGA4332COM Advanced WiFi Gateway Router User Guide
Make	Comcast Business
Language	English
Filetype	PDF (Download)
File size	0.88 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL WI-FI INSTRUCTIONS & USER MANUALS
• Comcast Business

Questions and Answers (0)

If you have any questions regarding COMCAST CGA4332COM Advanced WiFi Gateway Router User Guide, please ask here and describe the problem in detail.