FLEX FX4221 24V Trim Router Instruction Manual
OPERATION INSTRUCTIONS
To reduce the risk of fire, personal injury, and product damage due to a
short circuit, never immerse your tool, battery pack or charger in fluid or
allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater, certain
WARNING
industrial chemicals, and bleach or bleach-containing products, etc. can cause a short circuit.
If any parts are damaged or missing, do not operate this product until the
WARNING
parts are replaced. Use of this product with damaged or missing parts could
result in serious personal injury.
This TRIM Router must be used only with the battery packs and chargers listed below:
Battery Pack
5.0Ah 6Ah 8.0Ah
Charger
2.5Ah 3.5Ah
10Ah
12Ah
FLEX
FX0411 FX0421 FX0431 FX0451
FLEX
FLEX
FLEX
FX0111 FX0321 FX0121 FX0331 FX0221 FX0341 FX0231
NOTICE: Please refer to the battery pack and charger manuals for detailed operating
information.
SOFT START FEATURE
Fig. 19
The soft-start feature minimizes torque twist,
which is customary in router motors, by limiting
the speed at which the motor starts. This
increases the life of the motor.
BRUSHLESS
ON/OFF SWITCH (FIG. 19)
On/Off
Switch
To start the router, depress and release the
on/off switch once.
To stop the router, depress and release the on/
off switch again.
Always hold the tool and cutter bit away from
the workpiece when turning on the switch. Only
allow the tool and cutter bit to come into contact
with the workpiece after it has reached full
speed.
LED Lights
•
•
The LED lights will rapidly flash when the tool
and/or battery pack becomes overloaded or
too hot, and the internal sensors will turn the
tool off. Rest the tool for a while or place the
tool and battery pack separately under air flow
to cool them.
LED LIGHTS (FIG. 19)
The tool is equipped with 2 built-in LED
lights located around the collet. They provide
additional light on the surface of the workpiece
for operation in lower-light areas.
The LED lights will flash more slowly to
indicate that the battery is at low-battery
capacity. Recharge the battery pack.
The LED light will automatically turn on when
starting the tool, and will turn off approximately
10 seconds after the tool is stopped.
NOTE:
•
The LED lights will flash to signal that the
spindle lock is engaged when the On/Off
switch is pressed. Release the spindle lock
and start the tool again.
-19-
| General | Details |
|---|---|
| Name | FLEX FX4221 24V Trim Router Instruction Manual |
| Make | FLEX |
| Language | English |
| Filetype | PDF (Download) |
| File size | 2.88 MB |
(1 votes, average: 5.00 out of 5)
Loading...
If you have any questions regarding FLEX FX4221 24V Trim Router Instruction Manual, please ask here and describe the problem in detail.
TP-Link C201-V5 Wireless Dual Band Router User Guide
NETGEAR LBR20 ORBI LTE Router Instructions
LANCOM VPN 1793VAW Router Installation Guide
TP-Link AC1200 Dual Band Wi-Fi Router Installation Guide
Mercury Netcomm NF4V Fibre WiFi Gigabit Modem Router User Manual
ZYXEL LTE3301-PLUS 4G LTE-A Router User Guide
NETGEAR RS600 Nighthawk Wi-Fi 7 Tri-Band Router Owner’s Manual
ASUS RT-AX52 Dual Band Wi-Fi Router User Guide
FALCON 450-V2 4G 450 Router User Manual
DrayTek Vigor3910 Series Multi-WAN Security Router User Guide