FLEX FX4221 24V Trim Router Instruction Manual
INSTALLING AND REMOVING BITS
(FIG. 5, AND 6)
Fig. 5
12mm Wrench
Do not use bits with
WARNING
SPINDLE STOP™
Spindle Lock
damaged shanks.
Use protective gloves
WARNING
from the tool, or first allow the bit to cool
17mm
Wrench
when removing the bit
down. The bit may be hot after prolonged use.
Select the bit
This router is shipped with a 1/4” collet that
accepts cutter bits with 1/4” shanks.
1. Detach the battery pack.
Fig. 6
2. Place the tool upside down and remove
the base unit following above section “TO
REMOVE THE BASE”.
3. Slide the spindle lock down, until it audibly
clicks, to lock the spindle shaft in place.
Alternatively, you can use the 12 mm wrench
to hold the spindle securely.
Bit (not provided)
4. Use the 17 mm wrench to turn the collet nut
counterclockwise (Fig. 5).
5. Install or remove the bit/collet as follows:
•
To install a bit, clean and insert the
round shank of the desired router bit into
the collet so that the cutting surfaces are
approximately 1/8” (3.2 mm) to 1/4” (6.4
mm) away from the face of the collet (Fig. 6).
Tighten the collet nut
securely to prevent the
cutter bit from slipping. If the collet nut is not
tightened securely, the cutter bit may detach
during use, causing serious personal injury.
WARNING
•
To remove the bit, pull the bit out of the
collet.
6. Turn the collet nut clockwise to tighten the bit
using the 17 mm.
NOTICE: To prevent damage to tool, do
not tighten the collet nut without a cutter bit
installed.
7. Slide the spindle lock up to release the
spindle shaft.
NOTICE: To ensure proper gripping of the cutter
bit shank and minimize run-out, the shank of the
cutter bit must be inserted at least 5/8” (16 mm)
into the collet.
NOTE: The tool could be started only when
the spindle lock is released. The LED lights
will flash to signal that the spindle is locked
when the On/Off switch is pressed.
8. Install the base following above section “TO
INSTALL THE BASE”.
-12-
| General | Details |
|---|---|
| Name | FLEX FX4221 24V Trim Router Instruction Manual |
| Make | FLEX |
| Language | English |
| Filetype | PDF (Download) |
| File size | 2.88 MB |
(1 votes, average: 5.00 out of 5)
Loading...
If you have any questions regarding FLEX FX4221 24V Trim Router Instruction Manual, please ask here and describe the problem in detail.
MIKroTik D53G-5HacD2HnD Chateau 5G LTE Dual Band AC 5 Port Gigabit Router User Guide
motorola Cable Modem Plus N450 Router User Guide
ASUS BE6500 Dual Band Wi-Fi 7 Router User Guide
NETGEAR RS600 Nighthawk WiFi 7 Tri-Band Router User Manual
LANCOM SYSTEMS 1800EFW-5G Router Installation Guide
HUAWEI Outdoor CPE B2368 CAT12 LTE Router with Antenna User Guide
ASUS AX7800 Tri Band WiFi Router User Guide
D-Link DWR-930M 4G LTE Mobile Router Installation Guide
Ningbo Sunvot Technology Co Ltd LC600-202302 4G LTE CPE Router User Guide
TP-Link BE5000 Dual-Band Wi-Fi 7 Router Installation Guide