Home > FLEX > FLEX FX4221 24V Trim Router Instruction Manual

FLEX FX4221 24V Trim Router Instruction Manual

Circular Routing (Fig, 23, 24, and 25)  
Fig. 23  
Fig. 24  
Fig. 25  
For circular work, reassemble the knob and  
screw on the edge guide assembly as shown in  
Fig. 23 (smaller radius of cut) or Fig. 24 (larger  
radius of cut).  
Knob  
Center Hole  
The minimum and maximum radius of circles  
to be cut (distance between the center of circle  
and the center of bit) are 4-21/64” (110 mm) and  
9-29/64” (240 mm), respectively.  
1. Turn off the tool and detach the battery pack.  
Screw  
2. Securely attach the edge guide to the base.  
3. Align the center hole in the edge guide with  
the center of the circle to be cut. Adjust the  
length of the edge guide. Reconfigure it, if  
necessary, as shown in Figures 23 and 24.  
4. Drive a nail slightly less than 17/64” (6.5 mm)  
in diameter into the center hole to secure the  
edge guide.  
Center Hole  
5. Attach the battery pack, turn on the tool and  
allow it to reach its full speed.  
6. Gradually feed the cutter bit into the  
workpiece until the sub-base is level with the  
workpiece.  
7. Pivot the tool clockwise around the nail to  
make the circle cut (Fig. 25).  
8. When the cut is complete, turn the tool OFF  
and allow the cutter bit to come to a complete  
stop before removing it from the workpiece  
BRUSHLESS  
Nail  
Center Hole  
-21-  
GeneralDetails
NameFLEX FX4221 24V Trim Router Instruction Manual
MakeFLEX
LanguageEnglish
FiletypePDF (Download)
File size2.88 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

If you have any questions regarding FLEX FX4221 24V Trim Router Instruction Manual, please ask here and describe the problem in detail.

Leave a Reply

Your email address will not be published. Required fields are marked *

8 + 6 =

FLEX FX4221 24V Trim Router Instruction Manual