FLEX FX4221 24V Trim Router Instruction Manual
ADJUSTMENTS
Detach the battery pack
from the tool before
performing any assembly or adjustments, or
changing accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
Depth
Fig. 16
WARNING
Adjustment Ring
Depth Adjustment
Scale
Pointer
Zero
Mark
Base Lock
Lever
ADJUSTING THE DEPTH OF CUT
(FIG. 16 AND 17)
Bit
Workpiece
1. Select and install the desired cutter bit
following the instructions in the section
“INSTALLING AND REMOVING BITS”.
2. Open the base lock lever.
Fig. 17
3. Turn the depth adjustment ring until the bit
just touches the work piece. Turning the ring
clockwise raises the cutter bit (reduces the
cutting depth) while turning it counterclockwise
lowers the cutter bit (increases the cutting
depth).
1
2
4. Turn the depth adjustment scale clockwise until
the zero mark on the scale lines up with the
pointer on the depth adjustment ring (Fig. 16).
5. Turn the depth adjustment ring
counterclockwise until the pointer lines up
with desired depth of cut marking on the
depth adjustment scale (Fig. 17).
of the motor.
NOTE: Each mark on the depth adjustment
scale represents a depth change of 1/64”
(0.4 mm) and one full (360°) turn of the ring
changes the depth by 1/2” (12.7 mm).
•
•
Always make several progressively deeper
cuts. Start at one depth and then make several
passes, increasing the cutting depth each
time, until the desired depth is reached.
6. Close the base lock lever.
Making a cut that is too deep will put stress on
the motor and the cutter bit, and it may burn
the workpiece and dull the cutter bit. It could
also “grab” too much of the workpiece and
result in loss of control of the router, causing a
serious accident.
NOTICE: Making a single deep cut is never
advisable. Smaller diameter cutter bits are
easily broken by too much lateral thrust and
torque. Larger cutter bits will cause a rough cut
and will be difficult to guide and control. For
these reasons, do not exceed 1/8” (3.2 mm)
cutting depth in a single pass.
•
•
To be certain that the depth settings are
as desired, always make test cuts in scrap
material similar to the workpiece before
beginning the final cut.
Deep Cuts
•
Determining the proper cutting depth (for each
pass) should always be based on the material,
the size and type of cutter bit, and the power
Remember, knowing the right depth for each
cut comes with routing experience.
-17-
| General | Details |
|---|---|
| Name | FLEX FX4221 24V Trim Router Instruction Manual |
| Make | FLEX |
| Language | English |
| Filetype | PDF (Download) |
| File size | 2.88 MB |
(1 votes, average: 5.00 out of 5)
Loading...
If you have any questions regarding FLEX FX4221 24V Trim Router Instruction Manual, please ask here and describe the problem in detail.
CHEECENT QX210 Cellular Router User Guide
BOSSPAC EA000405 Border Router Instruction Manual
ASUS RT-AX57 AX3000 Dual Band WiFi Router User Guide
hitron CGNM-2250 Cable Modem Router User Guide
MALMBERGS 2700490DK 4G Network Router Instruction Manual
BELKIN F9K1001 N150 Wireless Router User Manual
REGIN M4G951 Router Instructions
TP-Link Archer BE805 BE19000 Tri-Band Wi-Fi 7 Router User Manual
perle IRG5410 Router User Guide
KuWFi CF5 4G LTE CPE Router User Manual