GEWISS GW A9707 KNX/IP Router Installation Guide
6 ETS database parameters
The following parameters can be set in ETS.
6.1
“General” menu
6.1.1 Activation/Deactivation of the programming mode with frontal pushbuttons
Used to enable the activation/deactivation of the programming mode by simultaneously pressing the Pass
GA and Pass PhA push-buttons. The programming push-button is always enabled, and is not affected by
the configuration of the parameter in question.
6.1.2 Forwarding telegrams manual function
Used to enable and set the duration of the manual telegram forwarding function. When this function is
enabled, press the Pass GA push-button to activate/deactivate the forwarding of telegrams with a group
address, or press the Pass PhA push-button to activate/deactivate the forwarding of telegrams with a
physical address. In both cases, the forwarding settings that have been configured (filter or block) are
bypassed by manually activating the telegram forwarding operation.
6.2
“Routing (KNX -> IP)” menu
This menu contains the parameters for configuring the behaviour of the device when the telegrams transit on
the KNX BUS line, defining their blockage or forwarding towards the backbone.
6.2.1 Group telegrams (main groups 0 to 13)
Used to set the behaviour of the router during the transit of BUS telegrams sent to a main group address
between 0 and 13. The values that can be set are:
block
If this value is set, all the telegrams that transit in the line/area handled by the router, and are being sent to a
main group address between 0 and 13, are not forwarded to the backbone (IP).
10
| General | Details |
|---|---|
| Name | GEWISS GW A9707 KNX/IP Router Installation Guide |
| Make | GEWiSS |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.38 MB |
If you have any questions regarding GEWISS GW A9707 KNX/IP Router Installation Guide, please ask here and describe the problem in detail.






























