Home > GEWiSS > GEWISS GW A9707 KNX/IP Router Installation Guide

GEWISS GW A9707 KNX/IP Router Installation Guide

7 Programming  
The KNX/IP Router can be programmed via ETS in various ways:  
7.1 Via the KNX BUS  
The device must at least be connected to the KNX BUS. ETS requires an additional interface (e.g. USB) in  
order to access the BUS; in this way, both the physical address and the entire application (including the IP  
configuration) can be programmed.  
This type of programming is recommended if it is not possible to establish an IP connection.  
7.2 Via the KNXnet/IP Tunnelling connection  
No additional interface required. Programming is only possible if the device has already a valid IP  
configuration (e.g. obtained from DHCP).  
In this case, the router will be displayed in the interface configuration section of ETS and, after selecting it,  
you can download the configuration from the ETS project as for the other devices.  
7.3 Via the KNXnet/IP Routing connection  
No additional interface required. Programming is only possible if the device has already a valid IP  
configuration (e.g. obtained from DHCP).  
In ETS, the IP routing interface only appears if the LAN network contains at least one device that supports  
the routing protocol. The IP routing interface is displayed with the name of the PC network card. After  
selecting the interface, you can download the configuration from the ETS project as for the other devices.  
15  
       
GeneralDetails
NameGEWISS GW A9707 KNX/IP Router Installation Guide
MakeGEWiSS
LanguageEnglish
FiletypePDF (Download)
File size0.38 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

If you have any questions regarding GEWISS GW A9707 KNX/IP Router Installation Guide, please ask here and describe the problem in detail.

Leave a Reply

Your email address will not be published. Required fields are marked *

20 + 2 =

GEWISS GW A9707 KNX/IP Router Installation Guide