Home > worCOBALT > COBALT WAVE RTR-64×64 Router User Manual

COBALT WAVE RTR-64×64 Router User Manual

Chapter 2  
Chapter  
2
Installation and Setup  
Overview  
This chapter contains the following information:  
Installing and Setting Up the WAVE RTR-64x64  
Setting up the Initial Configuration  
Installing the optional Fan Kit  
Installing and Setting Up the WAVE RTR-64x64  
To install and set up the WAVE RTR-64x64:  
Note: If installing the optional fan kit, see “Installing the Optional Fan Kit” (p. 2-4).  
1. Assemble the Ethernet network connections to your LAN using Cat 5 or  
better Ethernet cables. Refer to Chapter 1 for the router’s rear panel  
component layout.  
2. Connect the DC power cable from the power supply brick(s) to the router  
frame low voltage power connectors. Using the proper power cord for  
your country, connect the AC power cord to the mains supply.  
3. Configure the device network settings as needed for operation in your  
facility.  
4. Hook up the SDI Source and Destination cables and the external  
reference signal if required.  
The Ext Ref is optional. The router will switch Crosspoint's based on the  
internal clock if no reference is connected.  
WAVE RTR-64x64-OM (V1.1)  
WAVE 64X64-RTR ROUTER PRODUCT MANUAL  
2-1  
GeneralDetails
NameCOBALT WAVE RTR-64×64 Router User Manual
MakeworCOBALT
LanguageEnglish
FiletypePDF (Download)
File size1.03 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

If you have any questions regarding COBALT WAVE RTR-64×64 Router User Manual, please ask here and describe the problem in detail.

Leave a Reply

Your email address will not be published. Required fields are marked *

5 × 1 =

COBALT WAVE RTR-64×64 Router User Manual