intwine connected ICG-150 Gateway 150 Cellular Router User Guide

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

ICG-150 USER GUIDE  

To use both Ethernet ports as a bridged LAN (basically a 2 port hub):  

Hover over Network and select WAN/LAN Switch:  

To change the WAN/LAN1 port to LAN, simply change the Interface Mode from WAN to LAN  

and press the Apply buton.  

To change the WAN port from DHCP to a Statc IP:  

Hover over Network and select WAN/LAN Switch. Verify that Interface Mode is WAN. Change  

the Type dropdown from Dynamic Address (DHCP) to Statc IP. Then completely enter the  

values in the IP Address, Netmask, and Gateway fields to match those desired.  

To configure the LAN IP address  

All LAN interfaces on the ICG-150 are bridged. This means that the Wi-Fi Access Point and any  

configured LAN Ethernet ports will all be on the same network. The default is a statc IP of  

192.168.2.1 with a netmask of 255.255.255.0. These values can be changed by hovering over  

Network and selectng LAN.  

Here you can change to either DHCP or change the specific statc IP setngs. Note that it is  

critcal to remember these setngs as they will be required to connect to the system aſter  

changes are made.  

13  

©2022 Rev 1. Intwine Connect. All Rights Reserved. | +1(216)314-2922 | info@intwineconnect.com | intwineconnect.com  

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	intwine connected ICG-150 Gateway 150 Cellular Router User Guide
Make	intwine connected
Language	English
Filetype	PDF (Download)
File size	0.51 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL WI-FI INSTRUCTIONS & USER MANUALS
• intwine connected

Questions and Answers (0)

If you have any questions regarding intwine connected ICG-150 Gateway 150 Cellular Router User Guide, please ask here and describe the problem in detail.